answersLogoWhite
Oil and Oil Filters
Chevy Silverado
Ford Expedition Eddie Bauer
Ford Expedition XLT

How do you reset change engine oil light 2002 silverado?

567

Top Answer
User Avatar
Wiki User
Answered
2009-04-17 03:14:39
2009-04-17 03:14:39

Lately I have not gotten it to work, but in the past I would turn engin off, press the brake to the floor, and press the gas petal down to the floor 3 times. Repeat this procedure until you succeed. After reading the answer to the same question on the 2000 model, I remembered that this is the correct answer for the 2002 model also. NEW ANSWER: Turn key on, DO NOT START. Push the gas pedal all the way to the floor 3 times. Then turn key off and then start engine. Light should flash and then go out. Just be sure that you let all the way off of the gas pedal each time. NEUTZ.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


try disconnecting the battery that resets your computer



when you disconnect your battery and reconnect it will reset cumputer



key on engine off press accelerator pedal to the floor five times very rapidly should reset


reset after the engine oil / filter change, service


engine code reader go to autozone its free tgere


The check engine light comes on to notify the driver that there is an issue. To reset the light, it is best to take care of the issue, or use a scanner that will clear any possible codes.


The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.


Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.


The check engine light does not come on for an oil change.


The check engine light has nothing to due with an oil change.


The service engine soon is the same as a check engine light. It has nothing to do with an oil change.


The check engine light does not come on when an oil change is due. The check engine light is for an emissions related failure. It is reset with a scan tool after the fault is repaired.


Turn the ignition key to the run position and pump the accelerator 3 times within 5 seconds.


unplug your battery for 15 minutes and it will go off


You use a scan tool after repairing the cause of the code that turned the light on.


how do you reset the check engine light on a 2005 Toyota tundra


It requires an OBDII engine scanner to reset the light. If you don't fix the problem that made it come on, then it will not do any good to turn it off. You need to have the engine scaned to see why it came on to start with.


After reading the codes with a scanner, and repairing the cause, you clear the code with a scanner



The change oil light is reset by turning the key on, engine off, and pressing the gas pedal three times.The check engine light can only be reset with a scan tool. The cause of the fault needs repaired or the light will return.


To change a check engine light the dashboard must be removed this is best done by a mechanic. To reset a engine light unplug the cars battery for half a hour.


There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.


That requires an OBDII engine scanner to clear the codes / turn light off. But if you have not FIXED the problem that made it come on then it will just come on again. Have engine scanned.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.