Brake pads? I have a 1997 Nissan 4 WD pickup and it has rear drum brakes. I didn't know they ever came with pads in the rear.
How do you remove rear brake drum from a 1993 Toyota pickup?
Notice there are two threaded holes in the brake drum. Insert a metric bolt into the holes and tighten until the drum pops off. Replace the stud.
Parts should be available at Auto Zone or Napa Auto parts
on the outboard side near the lugs.
Remove the tire and wheel from your 1988 Ford Ranger pickup truck. Remove the brake pads. When the brake drum is not loose you can tap on it with a hammer or mallet. Once the brake drum is loose it will slide off.
How do I release the frozen brakes on the drum of a 1965 Chevy 3/4 ton pickup
You'll only find it in manual for that vehicle.
Do the following to remove the brake drum on 1995 Isuzu Pickup. - Remove wheel from the brake drum- Remove the Philips screw that holds the brake drum to the axle plate. The brake drum is now free to be removed but is usually stuck to the lug bolts.- spray penetrating oil on the lug nuts (be sure to put card board below wheel to catch the oil that will run off.- Use a plastic hammer and hammer the drum off the axle plate. - An alternate way is to place a 2 x 4 across the top of the lug nuts and use two c-clamps to pry the drum off the lug nuts.
Brake drums can be resurfaced by turning the brake drum in a brake drum lathe. When the brake drum has deep grooves in it, it cannot be repaired.
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
Front disc/rear drum
If you are talking about a canter you need to take the half shaft out
Brake drum bent and shoes rubbing against it? Bad wheel bearing? You had the car sitting on the brake drum itself? If that's true Just replace the drum(s) it was sitting on it is possible they have bent out of shape. See if just the new drum will stop the noise if no replace the shoes aswell. Josh
The drum and the brake shoes.
Raise and support vehicle and remove wheel.Release parking brake.Remove brake drum. If drum is difficult to remove, screw in bolt to pull drum out.Remove retainer, return springs, adjuster and shoes.Remove retainer ring with suitable tool, then separate toggle lever and brake shoe.Reverse procedure to install.Adjust brakes and parking brake.
In case of cost..drum brake is better than disc brake.
They just pull off but parking brake must be released & you may have to tap it. Shoes tend to fit pretty tightly in there.
The purpose of a drum brake is to come to a complete stop with any veichle that may have drum brakes in the rear of the car.
You can remove the front brake drum, on your Kawasaki Mule 2500, by removing the wheel and axle. The brake drum will slide off.
how to remove rear brake drum on 1994 cavalier
how do remove the brake drum on a 1991 mazda 323
brake fluid leaking from a brake drum indicates the brake slave cylander on that wheel is leaking and needs to be replaced you will not see the actual leak with out removing the brake drum
Normally a brake drum is turned or resurfaced using a brake drum lathe. This is usually done at a shop specializing in brake repair, or at a machine shop. Those who have a suitable metal lathe can also turn brake drums.
Better hope it is not a drum brake- it was originally equipped with a disc brake caliper.