0
They don't really break. The internal seals deteriorate and fail. This results in the master cylinder not holding pressure. The repair is to replace it.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What all does the heaters master cylinder control in a car?
a heater does not have a master cylinder; 'master cylinder' goes with assisted braking.
Where is the master cylinder on 2003 Honda Odyssey?
Hi The master cylinder in the odyssey is where the break fluid tank it located under the tank
What all does a master cylinder control on a car?
just the slave cylinder, for your brakes.
Your clutch is leaking on the inside of your car?
The gasket to your clutch master cylinder is probably broken or cracked. or your master cylinder is bad.
When you push your break petal it goes to floor before it kicks in and it very weak What is wrong?
Master Cylinder is defective. Stop driving this car until you have this repaired.
Which item is not a part of the braking system master cylinder brake hose orifice tube wheel cylinder?
Which item is not a component of the breaking system? Master cylinder, break hose, orifice tube, wheel cylinder
Where is a Chevy Impala 2004 brake fluid sensor located?
In the master break cylinder
Can a leaking master or slave cylinder cause a car not to turn over in a manual transmission car?
No
What car part did Jacob need to finish his car?
Jacob needed a master cylinder to finish his car in Twilight.
Where is the shift solenoid located on a 1992 S1 Saturn Car?
There is no shift solenoid. There is a Master and slave cylinder instead. Master slave cylinder is bolts underneath the Brake Master cylinder. The slave cylinder is here: http://www.youtube.com/watch?v=AtrTcX8wym8 Video provided by Richpin :) -RC-
1973 Volkswagen master cyl location?
The master cylinder is typically on the driver's side of the VW. Usually, if you crank the wheel really far to the right, you can see and even reach the master cylinder without jacking up the car.
1991 Pontiac grand am stalls even after master cylinder replaced?
The brake master cylinder has nothing to do with the way the car runs. It certainly wouldn't cause it to stall.....Maybe the brake booster?
