This is because of the refractive propoties of the immersion oil. The oil works as a sort of secondary lens, magnifying the specimin in addition to the lens alresdy present.
beacause they gigady at the photoshoot
The purpose to use oil is to make it clear in the microscope. Oil is the quintessential "tool" to make oil immersion magnification possible. Oil has the same refractive index as glass, therefore the light is not bent by the air that would otherwise be in the oil's place.
If you are using the oil immersion objective on a microscope, you must use oil to increase the resolution of the lens. These lens are used at very high magnification.
In light microscopy, oil immersion is a technique used to increase the resolution of a microscope. This is achieved by immersing both the objective lens and the specimen in a transparent oil of high refractive index, thereby increasing the numerical aperture of the objective lens.
Liquid paraffin, also known as mineral oil, is commonly used with oil immersion objectives in microscopy because it has a refractive index similar to that of glass and the immersion medium used in the objective. This reduces the loss of light due to refraction and increases the numerical aperture, allowing for better resolution and increased imaging quality. Additionally, liquid paraffin has a high viscosity which helps to prevent the formation of air bubbles and ensures a stable imaging medium.
beacause they gigady at the photoshoot
because immersion oil has same refractive index as like lens glass of microscope so it give clear image of object
100x lens is used with oil immersion
Oil immersion is a technique used to increase the resolution of a microscope.
One advantage is that it increases the resolution and clarity of the image, this is very useful for viewing specimens that would otherwise be to small to see without the oil. However it can be very messy to apply the oil and can take time and be rather difficult to clean the slide and the microscope. Moreover the slide could become damaged if vertical movement is used a lot; this is because the work distance between lens and slide is very small.
oil immersion
when you lower or raise the condenser of the microscope the object which we like to observe will shows us in a clarity way.. for example Oil Immersion type we see the object very clearly, where as incase of light or bright field the condenser and lens has some distance due to that the object clearence also low as compare to that of Oil Immersion
The purpose to use oil is to make it clear in the microscope. Oil is the quintessential "tool" to make oil immersion magnification possible. Oil has the same refractive index as glass, therefore the light is not bent by the air that would otherwise be in the oil's place.
Cedar wood oil
If you are using the oil immersion objective on a microscope, you must use oil to increase the resolution of the lens. These lens are used at very high magnification.
In light microscopy, oil immersion is a technique used to increase the resolution of a microscope. This is achieved by immersing both the objective lens and the specimen in a transparent oil of high refractive index, thereby increasing the numerical aperture of the objective lens.
Wet mounts are not attached to the slide, it is "floating". If you use an oil immersion lens, you have to put a drop of oil on the slide cover so the light can correctly focus. The oil will cause the slide cover to stick to the end of your Oil immersion lens. When you focus the field of focus will stay the same since the slip cover is stuck to the lens. When you go to change objectives, the cover will travel with your oil immersion lense.