answersLogoWhite

0


Best Answer

Depends on how much money you are willing to spend.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How many miles can I get on a Chevrolet 4.3L engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many kL are in 43L?

.043


How many liters in 43ml?

.43L. 1000ml=1L


How do you clean and adjust the throttle body on a 1991 Chevrolet S-10 blazer 43L is it the same as a carburetor?

There is no adjustment required, but you can clean it with a carb cleaner.


How do you change the stock single exhaust to dual on a 1994 43L Caprice?

Use an exhaust made for an LT1 engine the blocks are identical it is the insides that is different. Will bolt right on.


Can you swap a 3800 supercharged 38l from a gtp into your 95 Chevrolet cheyenne that's two wheel drive and already has a 43l v6?

What year is the gtp, if 95 or newer yes, if gtp is in the 80's then no due to pollution restrictions today, and may have to change the computers from each vehicle. Each computer is set to specs for the engine it controls.


What transmission came in the 2002 43L s-10?

4L60/E l


What is the spark plug gap on a 1993 Chevy with a 43L V6?

1993 CHEVROLET K1500 PICKUP V6 4.3 (262) Z GAS engine 4207 PLATINUM PART Gap=.035 4449 PLATINUM+4 Do not Gap HR9BP PLATINUM PLUG Gap=.035 4302 PLATINUM2 Do not Gap HR10BC SUPER PLUG Gap=.035 7585 SUPER PART Gap=.035


How can you calculate the mass or the volume of 18-k gold?

43L of 18-k gold


Does a Chevy 305 mount to the same transmission as a 43L?

Yes it will bolt right up to it.


Where is the Oxygen Sensor on a 90 Caprice V6 43L?

There is one before and one after the catalytic converter.


Where can you check fuel pressure on a 1990 V6 43L Chevy Siverado?

The fuel lines around the filter; you will need an adapter.


How do you replace a egr valve in a 1995 gmc jimmy 43L Engine?

remove the intake hose and the exhaust port screwed into the egr valve, the remove the two retaining bolts from the intake and clean any old gasket material away. if possible run a piece of wire down the hole to make certain the passage is clear of carbon build up