To remove the engine cover on an Aerostar, first remove the two screws that hold the "black box" to the underside of the dash, below the ahstray. it is NOT necessary to unplug it! If there is a cup holder, remove the screw holding it and pull the rear up, until the friction fasteners let go. There are three latches, two on the right, one on the left. Release and clear the latches, move the cover down and rearward.
you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points, you have to remove the flywheel, take engine cover off, remove flywheel, its under it, next to the points,
were is engine cover wot does it do
It depends on the model year and size of engine cover based on the engine underneath. For 1996 and newer, you generally have to remove the passenger seat in order to get the cover out of the way.
remove the cover on top of the engine. the wies are om the igniter coils remove the cover on top of the engine. the wies are om the igniter coils
remove engine cover
The oil filter is located at the bottom of the engine. It can be remove with an oil filter wrench. Do not remove the engine top cover unless you need to repair something very major.
Removing an engine cover will help a person gain more access to the engine parts. The cover is removed with using a socket wrench to loosen the bolts/nuts in the cover.
Remove 2 bolts in front on the bottom of the engine cover. Remove 2 Phillips bolts in the ash tray area. and lastly there are two latches toward the back of the cover....one on each side. You then pull the bottom of the engine cover toward the rear and tilt the top out slowly. It's easy.
Follow the upper rad hose to the engine. You will need to remove the engine cover. To remove the cover turn the oil filler neck (not the cap).
Open the hood. Remove the black engine cover and flip it over. Remove the screws that hold the engine cover together and take the cover apart. The air cleaner inserts are inside.
remove cover from top of engine
Take it off
To remove an engine cover from a 2008 Volkswagen Jetta all of the mounting bolts need to be located. There are several around the engine bay. The clips for the air intake need to be removed as well. When everything is unbolt the cover can just be pulled off.
how to remove the timing cover for a landrover freelander diesel engine
Remove oil filler tube cap....then Wiggle and pull straight up.
check this out, it's same engine as in Rabbit http://rabbitownersclub.com/vw/showthread.php/engine-plastic-cover-4981.html
you un bolt it
You remove the upper timing belt cover and look at the belt while cranking the engine over.You remove the upper timing belt cover and look at the belt while cranking the engine over.
You must remove the Timing chain cover and engine girdle.
Disconnect the spark plug wires, disconnect the PCV-valve, remove four nuts holding the cover. Make sure that wires are not in the way. Remove the cover.
Pull it off
Simply pull up on the engine cover it is held in by four clips i believe. The cover with pop off with little strength used to pull it out of the clips . Then slide it towards the windshield to remove the air intake hoses. BK