0
There are 4 screws that need to be removed. they require a Phillips screwdriver for 3 and a Torx for 1. To remove panel: (This works for 1998 to 2000)
1) Remove one Phillips head screw from bottom of panel near rear of door. (If the bottom of panel is carpeted look for a hole in carpet near bottom rear of door)
(Skip steps 2 and 3 for electric windows)
2) Take a small flat-head screw driver (or use fingers) and pop off the top piece that covers the window roller handle. (It pops off at the shaft end and rotates out of the way staying attached at the knob end) (Skip this step if electric windows)
3) There is a Torx screw under the cover that screws into the center of the shaft. Remove it and window handle will come off.
4) Remove piece that has the door closer pull handle and buttons for window control if you have electric windows. There are 2 Phillips screws under the door handle. Remove screws then slide your finger in between that piece and the panel on the bottom side and then pull towards you. There are 3 or 4 clips that will pop out and the piece will pop away from the panel. If electric windows disconnect wires from bottom of that piece.
5) There is another Phillips screw in the panel under the just removed piece that needs to be removed.
6) Pull up on the entire panel and it should pop right off.
7) To put back on reverse procedure making sure you put the manual door lock lever through the hole in the panel before trying to push the panel back down on the locking tabs.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Remove door panel on a 2000 ford ranger?
Removing the door panels on a 2000 Ford Ranger is easy. All you have to do is snap out the old panels by unscrewing the bolts and screwing in the new ones.
Remove door panel on 1998 Ford Ranger?
The 1998 Ford Ranger door panel has eight retaining clips. Pry outward on each retaining clip. Remove the two door handle screws.
How do you remove the door panel on a 2000 Plymouth Voyager?
Go to this website. It will show how to remove the door panel.
How do you remove a passenger door panel on a 1997 Ford Ranger?
remove the window handle, remove screws from armrest, remove the inner door handle and the screw on the lower rear of the door panel, lift the panel upwards to remove from the slots along the bottom of the door.
How do you remove and replace your door ajar sensor on your 2000 ford ranger?
Pull the door panel off, remove the door latch assembly from inside the door, and replace the switch which is hold onto the latch with one screw on the backside of the latch.
How do you remove passenger door panel on ford ranger super cab?
What you do is you fart
How do you remove door panel on 2000 passat?
Magic
How do you remove door panel to get to speakers on a 2000 mustang?
Remove the screw under the door latch
How do you take off the door panel in a 2000 Kia Sephia?
Using a screw driver, remove the screws and remove the clips from the door panel. Remove the panel slowly, remove any wire connections, and pull the panel off the door frame.
How do you remove a rear door panel on a 2000 Kia Sportage?
You will need to remove the screws in the door. They are located in the door handle, the door latch and at the very bottom of the panel. Once you remove the three screws pull the panel and it will pop out.
How do you remove a door panel on a 2000 ford ranger?
there are screws under the handle and 2 at the bottom of the door panel. you will need to remove the window crank if you have one, and all u have to do then is remove the clip from behind the handle. if its power then all u have to do is unplug it from the back when u get the panel off. dont worry about being gentle there are plastic pins that hold the panel after you have it undone.
How to remove a door panel on a 1986 Ford Ranger?
YOU MUST REMOVE DOOR AND WINDOW HANDLES, ARM REST AND THEN YOU CAN POP THE DOOR PANEL WITH A LARGE SCREWDRIVER OR A REMOVAL TOOL FOR THE PASTIC PUSH IN RETAINERS
