Best Answer

Usually lower rear freeze plug on passenger side Usually lower rear freeze plug on passenger side

User Avatar

Wiki User

โˆ™ 2007-05-05 18:40:29
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: What location does the threaded block heater install on a 2.3L 4 cylinder Ford Ranger 2002?
Write your answer...
Related questions

Location of intake air temperature sensor on 1994 Ford Ranger with 2.3 Liter 4 cylinder engine? has a picture of the sensor and it is threaded , so it's threaded into the upper intake manifold somewhere ( at least that partially answers your question )

Location of clutch slave cylinder of 1994 ford ranger?

The hydraulic clutch slave cylinder is inside the manual transmission bellhousing

How much will a engine install cost for a ford ranger?

The labor time for a 2000 Ford Ranger with a 4 cylinder engine is 10 hours, or roughly $900. It could be more depending on the year of your vehicle and for the 6 cylinder engine.

How do i repair the slave cylinder on my 1988 Ford Ranger?

The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.

Install ignition 2002 Ford Ranger?

install ignition 2002 ford ranger directions

Can a 93 ranger 6 cylinder and transmission fit in a 92 ranger with a 4 cylinder?


What are the cylinder numbers on a Ford Ranger?

where is the number 3 cylinder located on a 2.5 ford ranger engine

How do you install a rear window on a 2000 Ford Ranger?

How do you install a rear sliding window on a 2000 Ford Ranger?

Will the manual trans from a 4-cylinder Ford Ranger bolt up to the bell housing of a 6-cylinder Ford Ranger?

I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?

Where is the Location of tension pulley on 2000 Ford Ranger 6-cylinder?

The tension pulley is centerline with the engine and at the very top of the belt routing.

What is the cylinder firing order for a 4 cylinder 1996 Ford Ranger?

Firing order for 1996 Ranger 4-cylinder engine is 1-3-4-2.

Can a 6-cylinder ranger transmission fit in to a 4-cylinder ranger?

Several factors are involved with the ability to swap these transmissions. Depending on the Ranger year, the bellhousing and clutch systems can be different sizes, as well as the mounts. With the year of the Ranger and the 6 cylinder transmission then you can determine if the switch is possible.

Where is number 1 cylinder 1996 ford ranger 2.3?

The front engine cylinder

How do you install 2003 Ford Ranger Driver Side View Mirror?

how to install Ford Ranger Driver Side View Mirror

How do you install headlight switch in 1991 Ford Ranger?

I need to know how to install a headlight swith in a 1991 ford ranger xlt

Cylinder location for 1999 Ford Ranger 4.0 v6?

Go to this site and CHECK IT OUT!

Does Ford Ranger have a alarm system?

Usually no, but you can install them yourself or get a shop to install it.

Daytime running lights module location on a 1995 Ford Ranger?

drl module location on a ford ranger 1995

Where is the slave cylinder on a 1997 Ford Ranger xlt?

The slave cylinder for a hydraulic clutch on a Ford Ranger is inside the manual transmission bellhousing

Why are there two spark plugs per cylinder on your 92 ford ranger?

This was a design Ford tried on the 4 cylinder engine. The 2 plugs per cylinder was supposed to give you a more complete burn of fuel thus increasing power and mileage. When replacing the plugs, install 8 on this engine.

How many bolts does a 1991 Ranger have in the transmission?

There are 8 bolts on a 4 cylinder Ford Ranger

What is the location of the fuse box on a 1991 ford ranger?

Location fuse box on 1991 ford ranger

How much horsepower does a 1998 Ford Ranger 4 cylinder have?

The 2.5 liter 4 cylinder engine in a 1998 Ford Ranger has 117 horsepower at 4500 RPM

What size engine comes in a 1994 Ford Ranger 4 cylinder?

The 4 cylinder engine is 2.3 liters ( 140 cubic inches ) in a 1994 Ford Ranger

What is the approximate cost to replace a cylinder in a 2003 Ford Ranger?

what sort of cylinder you want to replace?