0
What size sockets are required to remove the starter from 2000 Blazer?
Wiki User
∙ 14y ago
9/16 for the starter bolts, either 1/4 or 5/16 for the ignition wire and either 14 or 15 mm for the power wire from the battery
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change the starter on a 1997 Chevy Blazer?
Remove the positive battery cable from your 1997 Chevy Blazer battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
How do you change the starter on 1987 blazer s-10 with manual trans?
Remove the positive battery cable from your 1987 Chevrolet Blazer battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
How do you remove the starter from a 92 S10 blazer?
how to remove the starter from a 92 s-10 4x2 with a 2.8 engine
How do you remove 97 Chevy Blazer starter?
Start by disconnecting battery . Remove flywheel cover on transmission .Remove 2 bolts holding starter to block. Slide starter back and drop down to remove wires from starter.
Starter relpacement 1995 blazer?
Disconnect the negative battery cable from the battery, remove the two bolts from the starter, drop the starter enough to disconnect the wires from it and remove the starter from the engine.
How do you replace starter on a 79 350 Chevrolet. blazer?
Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
How do you remove the torque converter bolts on a 1996 Chevy blazer?
Remove the starter and remove the protector places behind the started
How do you remove a starter out of a 1985 Chevy Blazer?
Take the positive cable off the battery, then you have to remove the inspection shield on the transmission and then take the two bolts out of the starter
How do I change the starter on my 1986 Chevy Blazer?
the only way i could figure out how to get the starter out was to remove the right engine mount
How do you replace the starter in a 1999 Chevy Blazer?
on a 2002 4 wh drive Blazer - disconnect the battery - lossen starter bolts ( 2 ) loosen and remove the Flywheel plate that the Starter is inserted into or you wont be able to pull the starter out - really tight space 2 bolts to remove this plate - plate has an opening that the starter goes into to engage the flywheel
What tools do you need to change a starter on a 1994 Ford Bronco 302?
all you need are wrenches to disconnect battery cables, and sockets and extensions to remove starter blots from starter
Trick to removing the starter on a 95 Chevy blazer?
to remove the starter on the 4.3 Blazer, remove all the bolts EXCEPT THE UPPERMOST ONE on the driver's side, on the flywheel housing. this will allow you to slide the housing about 1/2" - 3/4" back, and the starter will drop free. then it's a few twist and jiggling so you can get to the lugs that hold the wiring in place. it's easier to get the starter bolts back in if you put the housing back to where it will keep the starter from dropping. I just went thru this yesterday - I looked it up on the internet; "remove starter on 4.3 Blazer".
