the VQ30DE engine in the 2000 Maxima has 2 crank sensors, the 1st one is located directly under the crank pulley and the other one is located on the transmission bell housing facing the radiator fans where the engine and trans. meet.
where is the crankshaft angle sensor located on a 1997 cadillac deville.
in timing belt
Crank Angle Sensor (location)i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front of the car,about 5"-8". hope this helps.
It's fairly complicated. The sensor is located near the bottom to the engine behind the crankshaft pulley and timing belt cover. Not a job for an inexperienced do-it yourself mechanic.
On a 94 Turbo DSM there is no crank angle sensor. The Cam Angle Sensor(CAS)serves the function of both a crank and cam sensor, and it's located on the passenger side of the valve cover at the end of the intake camshaft, you can't miss it.
crankshaft sensor on your excel (presuming it is a DOHC model) is at the front of the engine. there is a small connector you'll see next to the exhaust heat shield, follow the wire from the connector down the block a little bit and that is the crank angle sensor (not to be confused with camshaft angle sensor which is located on top of the engine just behind the coil pack and next to the rocker cover).
In my '97 Eclipse GST (the convertible model of your car), the Crankshaft Position Sensor, or Crankshaft Angle Sensor, is located behind the crankshaft pulley. To get to it, the Mitsubishi shop manual lists the removal of the timing belt. Not a fun job. Since the timing belt will be removed anyways, this is a good time to install a new belt. The Mitsubishi dealership also suggested replacing the timing belt tensioner when re-installing the timing belt.
The Crank angle sensor should be on the flywheel aka harmonic balancer aka crankshaft at the bottom of the engine. The largest wheel for your accessory belts. There is a wire that conects to it
The crank position sensor is located on the bottom left hand side of the engine (when seated in the driver's seat). It is secured in place by two (2) 10mm screws above and to the right of the crank shaft main pulley.
If you are referring to the Crankshaft sensor, or crank angle sensor it is located on the passenger side of the engine compartment near the harmonic balancer. (For the 3.1 L) I have a 95 with a 3.1L and it had intermitant missing and starting problems. I replaced the crank position sensor (which was located behind the harmonic balancer) and the camshaft position sensor (located under the power steering pump) and it corrected the problem.
where is crank sensor located on 2003 kia sorento? The "CAS" Crank angle sensor is located directly above the crankshaft sprocket and right next to the timing belt tensioner arm & pulley. (It's nestled down in between the timing belt at the front bottom of the engine)
Crank angle sensor reads rpm and sends the signal to the ECU (computer) to aid in the calculation of engine rpm, ignition timing, fuel injection and crankshaft position.