If your standing in front of the car it is just to the right of the ignition system (where all the spark plug wires are). It's round and it has a line that goes to the intake hose just before it attaches to the aluminum intake on top of the engine. Being that the EGR is on top of the engine it shouldn't be too difficult to change, but I can't say for sure because I haven't done it. It's easy. All you need is a 10mm socket, 2" extension, and ratchet. Unbolt unplug and you're done.
Where is the blower motor for a 1997 lumina located?
Where is the blower motor for a 1997 lumina?
Under the air cleaner box
where is the oxygen sensor located on a 1997 Chevrolet lumina
The trunk release for a 1997 Chevy Lumina is located on the driver side floor. An emergency release is also located inside the trunk.
The fuel pump is located in the fuel tank (gas tank). Usually you need to pull the fuel tank out to replace the fuel pump
What is the avearage cost to fix a blow headgasket on a 98 lumina
Remove the wiring harness from the and of your 1997 Chevy Lumina antenna. Remove the antenna retaining nuts. Reverse the process to install the new antenna.
ok on a 1997 Chevy lumina, the fuel pump is located inside the tank, so yes you will have to drop the tank, the fuel filter is located on the frame if that's any help and vry easy to replace, its really not that difficult to change the pump.
A 1997 Dodge Dakota does not have an EGR Valve.
The PCV valve is located on top of the valve cover in the middle.
where is my cooling fan relay controll circuit located in a 1997 Chevy lumina, 3.1 engine
in gas tank
Replace if failed.
How do i replace the purge valve on a 1999 Chevy Monte Carlo
The 1997 Chevrolet Lumina shifter cable is held in place with a swivel nut on each end of the cable. Loosen the swivel nuts and the cable will come off.
where is the heater control valve for a 1997 ford expedition
Were is the PVC valve located
under pass seat
The 1997 Chevrolet blazer modulator valve is located on the firewall in the engine compartment. The valve will be on the passenger side of the firewall.
Its located on top of the valve cover. Just grab hold of it and gently pull it out of the gromet its in, then pull the small rubber hose off and replace the PVC itself and push it back in from where it came.
7.99 at autozone you have to order it .
on the valve cover closest to the firewall