Heater Cores and Blower Fans
Mazda MX-6
VW Jetta
Ford Explorer Limited

Where is the blower motor resistor on a 1989 Mazda MX-6 and how do you install it?

313233

Top Answer
User Avatar
Wiki User
2008-04-30 01:22:42
2008-04-30 01:22:42

The blower motor resistor is located under the glove box right behind the blower motor. There is a kick shield under the dash that needs to be removed. The resistor has three harnesses connectors. Unplugged the connectors. Remove the two screws holding it in place. If the resistor is highly corroded or broken, replace.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Generally the blower motor resistor is found close to the blower motor. It relies on the blower motor to keep it cool.

User Avatar

Inside the blower motor housing directly behind the electrical coupler.

User Avatar

A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.

User Avatar

Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.

User Avatar

The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.

User Avatar

Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.

User Avatar

Check the fuse. Check the blower speed resistor. Check the blower speed control switch.

User Avatar

The blower motor resistor has failed.The blower motor resistor has failed.

User Avatar

Locate the resistor under the hood near the blower motor on passenger side firewall. Unplug the electrical connector. Remove the screws holding the resistor in place. Remove the resistor. Install in reverse order.

User Avatar

The blower motor fan cools the resistor so the resistor is usually located close to the blower.

User Avatar

The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.

User Avatar

In general, the blower motor resistor is located close to the blower motor.

User Avatar

where is the blower motor resistor in a 2003 Mitsubishi eclipse

User Avatar

Your truck has both. the resistor is between the switch & blower.thje resistor controls the blower speed

User Avatar

The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.

User Avatar

The blower motor resistor is generally located close to the blower motor.

User Avatar

where is the blower motor resistor located on 2002 gmc envoy?

User Avatar

where is rear blower motor resistor on a 2001 odyssey

User Avatar

The 2001 Nissan Quest blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.

User Avatar

The blower motor resistor on a Mercedes 300e is located beneath the blower motor on the Mercedes 300e, if ever it needs replacing.

User Avatar

Check to see if you have 12 volts at the blower motor. If yes then the blower motor is bad. If no, then the resistor, relay, or fuse is bad.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.