0
It is located on top of the fiberglass AC housing that projects into the engine compartment on, the passenger side, held by 2 screws.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the blower motor resistor located on 2003 suburban?
The blower motor resistor is located under the glove compartment in a black shroud.
Where is the blower resistor on a 1999 K1500 Suburban?
Attached to the blower motor under the passenger dash
What is wrong if your blower fan motor only works on high speed on a 2002 Chevy suburban?
blower resistor is bad
Will replacing the blower motor resistor in the 1997 suburban correct the air output?
Replacing the 1997 Chevrolet suburban blower motor resistor can correct your air output issue. The air output issue could because by other things.
Where is the 1989 dodge ram 50 Blower motor Resistor location?
For the 1989 Dodge Ram, the heater blower motor resistor can be found on the passenger's side, on the bottom of the heater box. It is beside the blower motor.
How do you fix the blower fan on a 1994 Chevrolet Suburban?
You either have a blown fuse, defective blower motor, defective blower motor switch, or a defective blower motor resistor pack.
Blower fan only runs in high position for a 1989 Buick Lesabre?
Either the blower motor fan switch is bad or the blower motor resistor pack is defective. It is more than likely the blower motor resistor pack.
Where is the blower motor resistor in a 1989 Pontiac Bonneville?
Under the hood to the left of the blower motor mounted in the housing on the firewall...
Where is the blower motor resistor located on a 1994 GMC Suburban?
It is usually under the dash on the passenger side right next to the blower motor. On some, it is mounted on the same bracket as the blower motor.
Is there a relay for the blower motor in a 1989 dynasty?
Only for the high speed. The lower speeds are controlled with the use of a blower motor speed resistor.
How do you know if the blower motor resistor is bad?
A malfunctioning blower motor resistor will cause the blower motor not to work. When the resistor is bad the blower motors will not turn on.
Where is the blower motor resistor on a 1989 Mazda MX-6 and how do you install it?
The blower motor resistor is located under the glove box right behind the blower motor. There is a kick shield under the dash that needs to be removed. The resistor has three harnesses connectors. Unplugged the connectors. Remove the two screws holding it in place. If the resistor is highly corroded or broken, replace.
