answersLogoWhite

0


Best Answer
Copy

it is located near the front of the engine .or it is located at the side of the block..

WRONG! On the 2.3L/2.4L it is located on the front of the engine next to the oil filter. On the 2.2L engine it is located at the back of the engine next to the coil packs.

User Avatar

Wiki User

โˆ™ 2012-09-24 21:26:28
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the crank shaft sensor located on a 1998 Pontiac Sunfire?
Write your answer...
Submit

Related Questions

Where is the crank position sensor located on a 2003 Pontiac Sunfire?

2003 sunfire


Where is the crankshaft position sensor located on a 2001 Pontiac sunfire?

on the back of the motor wright below the crank sensor


Where is the crank sensor located on a 97 Pontiac sunfire?

on the 2.4 its to the left of the starter above the oil filter


Where is the crank sensor on a 1989 Pontiac sunbird 2.0?

Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.


Where is the crank sensor on 2003 grand am?

where is crank senser located on 2003 pontiac


Where is the crank shaft sensor located on a 1999 Pontiac Bonneville?

Where is the crank shaft located on a 1999 Pontiac Bonneville? I have bought the part. Just can't find where it goes.


Where is the crank shaft sensor located on a 1995 Pontiac trans am 350 motor?

Does your vehicle have the LT1? if so there is no crank sensor.. there is an optic sensor in the distributor that controls all..


Crank position sencer location on 2003 Pontiac GTP?

The crank sensor is located behind the hamonic balancer


Where is the crank shaft position sensor located on a 99 Pontiac Gran Am?

IT SHOULD BE LOCATED UNDER THE MANIFOLD BOLTED TO THE BLOCK


Where is the crank sensor located on 1990 Pontiac Sunbird?

I have a 1992 Pontiac Sunbird with 2.0 four cylinder in it, just found the crank sensor on it, to replace it. It is located on the FRONT side of the engine, below exhaust manifold and just above the A/C compressor. HOPE THIS HELPS SOMEONE ELSE!


Where is the crank shaft sensor located on a 2001 Pontiac Bonneville?

it should be on the right side right neer the belt


Where is the crank sensor located on 1998 Bravada?

the crank sensor is located just behind the crank shaft pully of the engine.


Where is the Gm 3800 series 3 crank position sensor located?

Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor


Where is the Crankshaft position sensor located on 2001 Pontiac grand prix 3.8l?

The crank shaft position sensor is located behind the harmonic balancer/crank shaft pully on the front of the engine. You can see the wires for the sensor run behinf the pully into a plastic housing.


Where is the crank shaft sensor located in a Audi a4?

Where is the crank shaft sensor located in a Audi a6


Where is the crankcase sensor located on a 2003 pt cruiser turbo?

It does not have a crank case sensor.It does not have a crank case sensor.


Where is the crank sensor located on 1989 camaro rs?

That year did not have a crank sensor.


Where is the oil pump on 96 Pontiac sunfire gt?

it is located inside of the oil pan. if you have low pressure and have high milage you could have bad crank bearing.


Where is crank sensor located on 1997 Dodge Ram van?

the crank sensor is located on the top front of the tranny


Where is crank sensor located on 97 sebring lxi?

where is the crank sensor located on my 1997 Chrysler sebring lxi


Where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5?

where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5


Where the crank position sensor is located?

where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine


Where is the crankshaft sending sensor located on a 1996 Pontiac Grand Prix?

The crank sensor should be located down next to the crank shaft, Right side of car They are hard to see, and i think you have to remove the crank pully to get the sensor out, this is a comon problem on the 3.8 L Gm. eng Not a very expensive part, Usualy the car won't start when faulty


Can timing in 1996 2.2 liter Pontiac sunfire be 180 degrees out?

1996 pontiac sunfire 2.2 crank was moved but cam was not could the timing get out 180 degrees before i put it back together


Where is the crank sensor on a 2000 Nissan Sentra?

where is the crank sensor located on 2000 nissan sentra