0
Where is the fuel pump located on a 1986 corvette easy to replace?
Wiki User
∙ 13y ago
It will be on the lower right(passenger) hand side of engine. Not hard to replace but can be hard to get at. Use a flare nut wrench to remove the gas line if a regular wrench slips. Just 2 bolts hold it into place. Install a new gasket, put some grease on the pushrod behind the pump to hold it up into motor and install new gasket, and pump with the two bolts. If pushrod does not move up into engine ,bump starter to nove the eccentric 1/2 turn then it will. Done. I hope this helps you. Mark
ok the only problem is, this location that Mark is talking about is for the carbureted engine,if the engine is fuel injected,the pump will be in the fuel tank and comes out the top of the tank where the fuel goes in.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Can you replace a 1976 corvette oil pan without pulling the motor out?
Yes, the crossmember for suspension is in front of the engine. Very easy job.
How hard is it to replace my car speakers?
It is a relatively easy job to replace your speakers depending on where they are located.
Where is the fuel tank in a 1986 Corvette?
Behind the tail lights. Where you fuel the vett. the gas cap is connected directly to the tank. Its real easy to change fuel pumps on these!
Where is the wiper motor on 1998 corvette and how do you replace it replace it?
the wiper motor is located under the black plastic cover at the bottom of the windshied on the outside of the car. remove wipers and about 6 plastic screws. the motor is held down by 3 bolts and is easy to remove. I puchased a rebuilt motor on e-bay for about $58.00.
Where is the starter on a 1986 Toyota Celica?
Starter is located under the exaust manifold to the right..... easy to get to..
You just had the radiator flushed and now your 96 corvette is running hot is an air bubble if so how do you get rid of it?
It could be you thermostat is bad.take it out and replace They're cheap and easy to install.
How do you replace the shifting synchronizers and the shifting forks in a 1986 ford f150 4 speed?
No easy task...you need a mechanic.
Are there any bulbs in the dash cluster on a 1988 Corvette you can replace?
Yes. Pull the plastic and you will see that they are easy to get too. Just becareful pulling them out. Replacements can be found at your local parts store.
How do you replace the fuel pump in a 1986 Corvette?
ITS LOCATED INSIDE THE GAS TANK, YOU HAVE TO REMOVE THE TANK ITSELF. I don't Think That's the correct answer. I believe the pump is in the tank, but it's verry easy to remove. Open the tank lid and remove the bolts on the plate around the filler tube. Dosconnect all the fuel and vent hoses and lift the plate straight up. the pump, filter and assembly are on the bottom of the suck tube.They will all come out in one piece.
Where is the speed sensor located on a 1999 Chrysler LHS and how do you replace it?
Just replaced them....there are two of them....they are located under the car on the driver's side...back behind the wheel...pretty easy to find...and easy to replace...just "unclip" them...and "clip" in the new ones....piece a cake.
Where is the fuel pump for a 1975 Corvette?
Easy one. It's a mechanical pump located on the right (passenger) side of the engine close to the bottom. There will be at least two metal lines coming from it. If you replace it, be sure to put a little heavy grease on the shaft inside the motor to keep it from sliding down. If it slides down and you tighten on the pump on it, it will break. Done that myself. It's an easy job.
What is an easy way to change the bulbs for the console gauges on a 79 Corvette?
I
