answersLogoWhite

0


Best Answer

located below the oil filter

User Avatar

Wiki User

βˆ™ 2006-04-10 22:30:33
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the oil pressure sending unit located on a 1989 Ford Ranger?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel pressure regulator located on a 1989 ford ranger?

The 1989 Ford Ranger fuel pressure regulator can be found on the top of the engine. The fuel pressure regulator will be behind the fuel injector pump.


Where is the pressure gauge sensor on the 1989 Ford Ranger 4 cylinder 2.3 engine?

The oil pressure sending unit is located on the drivers side of the engine on the rear of the head. It has one wire going to it. It's a pain in the butt to get to. I'm looking for the temp sending unit on my 89 4cy ranger. Any idea?


Where is the oil sending unit located on a 1989 Ford Ranger?

UNDER HOOD, DRIVER SIDE, LOWER ENGINE AREA, MOUNTED ON SIDE OF OIL PAN.


Where is the oil pressure switch on a 1989 Ford Ranger 2.3 L engine?

the oil pressure switch is located in the rear of the engine compartment on the drivers side under the valve cover


Where is the voltage regulator located on a 1989 Ford Ranger?

it is inside the alternator


Where is the ignition module located on a 1989 ford ranger?

The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the oil pressure sending unit located on 1989 Jeep Wrangler?

If you have the 4.2, it is on the passenger side of the engine near where the dipstick enters the block, forward of the starter.


Where is the oil pressure sending switch on a 1989 GMC Sierra not the fuel pump relay?

The oil pressure sending unit on a 1989 GMC Sierra is located slightly above the oil filter. You will need a flashlight to find it. It may be hard to recognize it because it should have a heat shield around it as well. Look for its wire coming down from the engine compartment and follow it to the oil pressure sending unit. Drain your engine oil and remove the oil filter to make changing the oil pressure sending unit easier.


Where is the 4x4 switch on a 1989 Ford Ranger?

on the 88 ranger the switch is above your rearview mirror located on the ceiling on the 88 ranger the switch is above your rearview mirror located on the ceiling


Where is the oil pressure gage on the 1989 Pontiac Bonneville?

the guage should be located in your dash next to the speedometer, but if you are reffering to the pressure sending unit it is located on passenger side, behind the powersteering pull best accessed for wheel well or from below the car


Where is the Temperature gauge sending unit on a 1989 Honda accord lxi?

The temperature gauge sending unit, located on a 1989 Honda Accord LXI is located on the thermostat. It is the small connection with a single wire sticking out of it.


Where is the oil pressure sender on 1989 astrovan?

You need to remove the dog house (rear engine cover). The oil pressure sending unit is located next to the distribiture. It usually has a plug with just one wire.

People also asked

Oil pressure sending unit on 1991 ford ranger 2.3?

View results

Where is the oil sending unit on a 92 ranger 2.3?

View results