Look at the back of the engine where the clutch line goes in the engine. 3 bolts to take out and it's in your hand.
Look at the back of the engine where the slave is for the clutch. The bleeder is right there. Just follow the hyd. line on the right side.
In cylinder
It has to be on the slave cylinder, not sure that was your question.
== == == ==
Its on the slave cylinder which is on the front of the transmission just left of the front engine mount bracket. It looks just like a brake bleeder screw.
right nest to header is the clutch slave cylinder it has a bleeder screw
You will find the bleeder valve on the Slave Cylinder, which is mounted on the front of the transmission, by the radiator. You will find it in the front and center of the engine compartment.
The same way you bleed brakes, but use the little bleeder valve on the slave cylinder. The same way you bleed brakes, but use the little bleeder valve on the slave cylinder.
Fill Master cylinder Open bleeder on slave cylinder Let fluid run from slave Close bleeder install hose to bleeder on slave Run other end into container partially filled with fluid Have assistant step on clutch Open bleeder Observe fluid running into container Repeat until fluid runs clear (No air bubbles) Tighten bleeder securely
Probably on top of the slave cylinder
The bleeder is above the hydraulic hose connection.
Right above the slave cylinder there is a bleeder screw. Just unsrew it and have someone hold in the clutch to start the bleed.