Disconnect the wire.
Screw out the old one.
Screw in the new one.
Connect the wire.
If you don't use the special socket to fit over the sending unit you risk damaging the unit. Also do not over tighten the unit, it has 1/8" pipe thread and requires a little thread sealant and only snug it up.
most fuel sending unit are coneccted to the fuel pump on the top of the gas tank the gas tank needs to be takin out completely the sending unit/fuel pump is at the top of the tank it is a complete unit. You will need another new gasket when replacing the old one with the new one Or if need be you can buy Gasket maker from you local auto parts store less exspensive yet time consuming
The oil sending unit is located behind the distributor. It looks like a a little can about the size of baby food jar. It has one wire coming from the top of it.
Thes sending unit is located inside gas tank.
You can pull the transmission or engine, witch ever you think would be the easyest for you. But you have to remove one of them to replace the rear main. It is a 1 piece seal and it drives over the back of the crankshaft.
It will take and experience mechanic six hours to replace your 1996 Chevy truck flywheel. A novice mechanic will take several more hours.
it may have a used engine from a 95 truck put in it. Or, it could be a late 1994, and Toyota was installing 1995 starters on the last of the production run for that year.
Back of the engine, on the top next to the distributor.
how long does it take to replace a carburetor on a chevy truck?
In back of the engine, on top, just to the drivers side of the distributor.
replace heater core in a 1991 Chevy work truck 1500
what would cause a oil pressure gauge to fluctuate on my 99 Chevy truck silverado i change the sending unit it does it mostly after it warmed up
well what kind of truck and what engine?
In most cases it's the sending unit in the gas tank at fault. It would require dropping the gas tank to replace the sending unit.
Most of the time, the fuel gauge is not the problem. The problem rests with the sending unit in the fuel tank. To fix it, you must replace the sending unit. This is done in different ways depending on the position of the tank in your particular truck.
Where is the fusible link in a 2005 Chevy HD truck
Yes there the same.