Chrysler LeBaron

A 1985 Chrysler Le Baron 2.2L may stop running when hot due to several potential issues, such as a failing fuel pump that can't maintain pressure at higher temperatures, a malfunctioning ignition module that overheats, or a clogged fuel filter restricting fuel flow. Additionally, failing engine sensors, like the coolant temperature sensor, could provide incorrect readings, disrupting the engine's air-fuel mixture. Lastly, vapor lock in the fuel system can occur when the fuel vaporizes due to heat, preventing proper fuel delivery.

In a 1990 Chrysler LeBaron, the body control module (BCM) is typically located under the dashboard on the driver's side. It is often mounted near the steering column or behind the fuse box. To access it, you may need to remove some trim panels or the driver's side kick panel. Always consult a repair manual for specific instructions related to your vehicle model.

The fuel relay switch on a Chrysler LeBaron is typically located in the engine compartment, often near the battery or the power distribution center. In some models, it may also be found under the dashboard on the driver's side. Refer to the vehicle's service manual for precise locations and diagrams, as they can vary by model year. Always ensure the vehicle is turned off before inspecting electrical components.

To change the fuel filter on a 1994 Chrysler LeBaron GTC, first, relieve the fuel system pressure by removing the fuel pump relay and starting the engine until it stalls. Next, locate the fuel filter, which is typically along the fuel line under the car or near the fuel tank. Disconnect the fuel lines from the filter using a line wrench, remove the old filter, and install the new one, ensuring the flow direction matches the markings. Finally, reconnect the fuel lines, replace the fuel pump relay, and start the engine to check for leaks.

If the passenger seat in a 1993 Chrysler LeBaron won't tilt forward, it could be due to a few common issues. The seat release lever or mechanism may be jammed or broken, preventing the seat from moving. Additionally, debris or obstructions under the seat could be blocking its movement. Lastly, the seat's mounting bolts might be loose or corroded, hindering its ability to tilt.

To set the timing on a 1995 Chrysler LeBaron, first ensure the engine is at top dead center (TDC) on the number one cylinder. Next, locate the timing marks on the crankshaft pulley and the timing cover. Align the marks according to the specified timing setting, which is typically around 10 degrees BTDC for this model. Finally, tighten the distributor hold-down bolt and recheck the timing to ensure it remains in the correct position.

The PCV (Positive Crankcase Ventilation) valve on a 1988 Chrysler LeBaron is typically located on the valve cover. It may be positioned on the driver's side, near the rear of the engine. To access it, you may need to remove any engine cover or components obstructing the valve. Always consult your vehicle's service manual for specific guidance.

On a 1992 Chrysler LeBaron, the hideaway headlamp cover motor is typically located in the front of the vehicle, attached to the headlight assembly. You may need to remove the headlight assembly or access it from the engine compartment to reach the motor. It’s usually situated near the fender and connected to the headlamp doors via linkage. Always consult the vehicle's service manual for precise details and guidance.

On a 1990 Chrysler LeBaron with a V6 engine, the oil sending unit is typically located near the oil filter, on the engine block. It is usually positioned on the driver's side, towards the back of the engine. To access it, you may need to remove any obstructing components, such as the air intake or other hoses, depending on your specific model and engine configuration. Make sure to consult a repair manual for detailed diagrams and specific instructions.