0
Chrysler LeBaron
Chrysler LeBaron was a luxury car produced by Chrysler in the 1930s. It became the strongest competitor of other luxury car brands such as Packard, Cadillac and Lincoln
927 Questions
You can find a turn signal lever for your 1986 Chrysler LeBaron Marc Cross Edition convertible at auto parts stores like AutoZone or O'Reilly Auto Parts. Online retailers such as eBay, Amazon, or specialized sites like RockAuto may also have the part available. Additionally, you could check with local junkyards or classic car parts suppliers for used or refurbished options.
How do you remove the rear seat in a 1993 Chrysler LeBaron convertible?
To remove the rear seat in a 1993 Chrysler LeBaron convertible, start by locating the seat cushion release clips or bolts at the front of the seat. Pull or unscrew these fasteners to detach the seat cushion, then lift it out. Next, access the rear seat back by locating the bolts or clips securing it to the vehicle frame, usually found at the bottom or sides. Remove these fasteners, and then gently pull the seat back away from the body to fully detach it.
Where is ecm on 1990 chrysler lebaron?
The Engine Control Module (ECM) on a 1990 Chrysler LeBaron is typically located in the engine compartment, mounted on or near the firewall. It is usually positioned on the passenger side, close to the battery. To access it, you may need to remove some components or covers, depending on the specific layout of your vehicle. Always consult the vehicle's service manual for precise location details.
How do you get the top down on a 1994 Chrysler lebaron V6?
you pull the two latches above the sun visors and then there is a button on the center console
What causes code 26 in the ecm on a 89 lebaron 2.5 turbo need help badly i am stranded?
Info can be found here http://www.allpar.com/fix/80s-codes.html
26 Peak injector circuit voltage has not been reached (need to check computer signals, voltage reg, injectors) (SEE NOTE #4 BELOW)
NOTE #4.During cranking, the computer will test the current through the injector to see whether there's too much resistance in the injector's path. If there is, code 26 is set.
The problem may be cured with tuner cleaner on the connectors.
For TBI engines, the injector's cold resistance should be between 0.9 and 1.2 ohms (specs vary with year). This is a peak-and-hold injector. With the engine idling the peak period should be about 1.2 milliseconds whereas the hold period will vary. If it's lower than this at idle, then the injector's shorted or there's a defect in the injector driver circuit. (Bohdan Bodnar)
What are the 1989 LeBaron Coupe colors?
White, red, two-tone pewter grey, and I believe there was a medium blue, in descending order of popularity. Nearly all are white or red, occasionally you'll see the pewter.
94 Chrysler lebaron set timing and replaced water pump and now it wont start why?
did you make sure the #1 piston was top dead center and that when you set your timing that the springs where without tension? if not its out of time
Where is the sensor for the electric fan on a 1993 Chrysler LeBaron?
the switch whether you have a 4 cyl or a v-6 is located near the thermostat housing. they are a two wire temperature sensor that the computer uses to turn the radiator fan on and off
What Causes a 1992 Chrysler lebaron to click click when turn the key and wont start?
A sing l e click is usually a failed starter. A repeated fast click is either a weak battery or a dirty battery cable.
Where can you find a Chrysler 3.0 52mm throttle body?
Didn't note when this was posted... I'll answer anyway; 1987-88 3.0s came with 52mm units as did the 3.3s (NON-LH) and 3.8s. The early 3.8s had 58mm TBs but they are very difficult to find. For my '93 I had to cap the two vacuum ports on top of the TB as they were not connected like the earlier models. The LH (Intrepid, etc) TBs are VERY different and more or less not interchangeable.
Your shocks or worn bushings are the most likely causes.
Check your netural safety switch. Losated on either the lower steering colum inside the car, or ont the transmission where the shift cable connects. The previous owner may have removed the bulb or it's blown.
How do you take the door panels off of a 1989 Chrysler Lebaron GTC to raise the window up?
Power windows? Well the panels have to come off to fix that anyway. Down at the bottom of the door panel where the pocket section is, there are 4 screws hidden in the carpet. They are super hard to see, but feel around and use a strong light to look for them. Then if you have speakers in the door, carefully pry off the grill and remove the hidden screws. If I recall correctly, the next screw is around the door handle, underneath it? The door panel is only held on by clips once the screws are removed. Jiggle it around and lift it upwards.
The rears are double duty speakers. They do bass and mid ranges. They use them So they didn't have to use 4 speakers, but they look like normal speakers to us. they use all 4 wires going to them, you may not have bought the correct type of speaker to replace them with
Where is the starter on a 1990 6 cylinder Chrysler LeBaron?
Hi, the starter is on the side of the engine which is actually the front because it is a "side winder" engine. If you are looking at the front of the car, it's right behind the middle of the bumper. Crawl underneath and you will see it just to the left of the oil filter looking up. However, you can also see part of it by lifting the hood and look down. It will be a little lower and to the right of the oil filter. To change it though, you will need to do it from under the car. rtalk7 if your under your car looking were your motor bolts to the transmissiom it would be towards the front of your car were your motor mount is. their will be 2 or 3 bolts holding it in, might have to support motor cause bolts go through the motor mount bracket
Where are the freeze plugs on a 1994 Chrysler LeBaron?
Four cylinder, rear and transmission side of engine block.
Six cylinder, front rear and transmission side of the engine block.
What is the coolant capacity for a 1989 LeBaron 2 point 5 Turbo 4 cylinder?
The coolant capacity is 9.0 quarts app. Be careful to purge the cooling system on this motor bcause if it has any air in the system at all after flushing or replacing a substantial amount of coolant the motor will very easily overheat which could cause serious damage. There is a bleed valve on the thermostat housing to aid in removing (purging) air from the system. Run the engine until the car is at operating temperature and the thermostat is open then open the bleeder valve some on the thermostat housing. It may spit and hiss some while air is coming out and when there is just coolant and no more air close the valve and top off with more coolant to the recovery tank. Please remember the need to be very careful when working with any hot coolant that is under pressure.
Where is the thermostat located on a 1995 Chrysler lebaron 3.0l?
It is under the housing where the upper radiator hose attaches to the engine.
What transmission is in a 1991 Chrysler LeBaron?
Three speed is called a 31th (A413) overdrive is called a 41te (A604)
