Chrysler

Under the car on a lift

Looking at the video.. The car is a 1965 Chrysler 300.. identified by the red 4 point "star" emblem in the grill. it is the "standard" 300 vs. the 300 L (sliver "star" in grill) 1418 Chrysler 300 convertibles were built in 1965

They weigh at least 200 pounds My 1979 70hp Chrysler weighs in at about 285lbs

There are NO sight glasses used on 1994 to date Chrysler meaning you need the knowledge and equipment to recharge the A/C system the consequences are damage to the system because of lost oil in the system or high pressures caused by over filling with R134.

If you don't have 2 keys you'll need to call a locksmith or the dealership. Before you call the locksmith, make sure you have the four digit PIN code to your vehicle. The dealership has the PIN code and will give it to you for FREE with proof of ownership to the vehicle. The can also give you the key code which is helpful at the same time. Add a key when you already have two: 1) Insert one the programmed transponder keys into the ignition lock cylinder and turn the switch to the "ON" position 2) The key should be in the "ON" position for 5 seconds but not more than 15 seconds. Turn back to the "OFF" position. 3) Within 10 seconds, insert second programmed transponder key into the ignition and turn to the "ON" position. The VTSS ( Vehicle Theft Security System ) or Immobilizer System lamp (depending on model ) should start to flas. An audible tone will indicate the system has entered the " Programming Mode ". 4) Within 45 seconds, turn the switch to the "OFF" position. Insert the new transponder key and turn the switch to the "ON" position. After approx. 10 seconds and audible tone will sound and indicator lamp will illuminate briefly. This will let you know key has been programmed. 5) To add aditional keys, repeat steps 1 - 4.

Dealer using a scan tool in the body control module.

Remove wheels then push back the pistons then remove calipers and brackets then the rotors.

The main difference is the length. The 'Grand' is about 12 inches longer, giving more storage space behind the back seat.

If the gear shift isn't free at all then there could be a problem with the shift censor. If this isn't the case then the linkage in the transmission is broken.

There are NO FACTORY kill switches on any Chrysler car

try taking out fuse from box!

with a scan tool or disconnect the battery count to ten then replace cable

Basics, If the battery is OK and the starter just clicks it is the starter. If the starter turns the engine over but won't start it could be a crankshaft or camshaft sensor or fuel pump. It needs to be diagnosed or it can be extremely costly to just replace a lot of unnecessary parts in it.

ya if there is enough room in the engine compartment. but you might have to put a bigger transmission to handle that 440 .

Not for a novice, lots of screws,bolts,clips and small and big pieces, they you have to remember where every screw bolt etc goes. Then when you are done you have to put up with the dozens of squeaks and rattles.

1 bench seat for 2-3 people. no rear seat.it has 2 seats

Your tires need to be "high speed" balanced.

Older models have plastic clips on them, newer ones have red color locks that have to be pushed open

As many as a box of crayons

The best way is to open the cylinder bleeder and let gravity work,when fluid flows without bubbles close the bleeder.

consult a service manual wiring diagram information page.

Remove wiper arm then remove inside trim panel being careful not to crack it then remove motor connection then motor

it is Michael c. hall from dexter on shotime

it is above the inboard edge of the fuel tank.

The proposed merger between the Daimler Corporation and Chrysler was to be the merger between two equally prominent companies to create an enhanced global brand. Daimler outlined a strategy using technology, product design, and good customer relations to give the company a competitive advantage. However, the Daimler Corporation later admitted it had never intended to form a partnership with Chrysler, and it was always been intended as a mere acquisition, not an equal partner. Apparently, the only reason they had claimed that it would be a partnership, was to fool the public and stockholders.