Dodge Laramie

Doesn't have one.

Check the serpentine belt or Thermostat stuck.

The axle nut is 1 11/16 in

in fuse box under the hood

stock they are 160hp and 400 ft.lbs torque.

All that is required to restart a 2006 Cummins is to add fuel and crank the engine. The fuel system is self bleeding.

youll most likely have to buy the whole hub assembly. I had to do that to my 94 dodge dakota.

The throttle pedal is not adjustable on a2001 Ram.

in the steering collum behind the steering wheel

It can vary from 8 mpg to 15 mpg

It means there is information or a message, such as oil change due,

Standard 8 bolt.

3/8 inch Allen wrench

you should use the medium rating octane(may vary depending on station)but usually 89 octane

A 2006 Dodge Ram does not have a cabin air filter.

The transfer case on a 2004 Ram uses ATF+4.

You need a scan tool.

cheapest way is to get a superchip for it. next step up and much better is a programmer. other things you can do are things such as turning up the turbo/getting a bigger turbo. if you want to go extreme then you can get bigger injectors, intake, exhaust. just a thought but you can take the muffler off and straight pipe it also. this will make it louder but i think it sounds VERY nice.

there is a big difference one is a 2500 and the other is a 1500 the 2500 has a bigger frame and different susp made to haul more weight

there is no diffence a 1500 mega cab is the same as a hemi 2500 the 2500 just cost more with a 3 42 ratio u can tow 8800 with a 3 73 9900 with a 4 10 11700

A 2010 Ram with the Hemi does not have a mass airflow sensor.

Hire a professional mechanic, or buy a repair manual.

Found the right front wheel ABS sensor wires had been pulled from the plug itself. Installed a new sensor and bam all the problems gone everything back to normal.

Follow the hose that comes out the top of the radiator, remove the hose where it clamps on to the engine and the small hose next to it. Remove the top bolt from the altinator and there are 3 or 4 bolts on the peice the hose hooked to that you need to take out. Pull that peice off and your thermostat is inside it, replace it and put every thing back together.

The difference between the two is this:

The Laramie has the following features above the SLT

Hemi Engine as Standard Equipment

Woograin Dash, Door Trim

Power Seat on Driver's Side

Extra Power Outlet

Leather-Faced Seats

Chrome-Clad Wheels

More Body Insulation

Fold Flat Load Floor

Storage under Center Front Seat

Auto-Dimming Rearview Center Mirror

Hands-Free Bluetooth

Homelink Garage Door Opener

Infinity 7 speaker System

Security Alarm

4-Wheel Antilock Brakes

Traction Control

Stability Control

Remote Start

Brake Assist

Audio Controls Mounted on Steering Wheel

Leather-Wrapped Steering Wheel

Different Front Lower Fascia

Fog Lamps

Lumbar Support for Driver and Passenger

Chrome Side Moulding

60/40 Split-Folding Rear Seat

Heated Front Seats

Hood Insulation

Glove Box Light

Ash Tray Light

Cupholder Light

Auxiliary Transmission Cooler

Laramie is about $5,000 more than an SLT model

It is considered the top-of-the-line Dodge Ram, equivalent to a Limited or Platinum Competitor's model.

DEPENDS ON THE YEAR I GUESS Becasue my SLT also has

Power Seats, under seat storage front and back, 60/40 rear seat, fog lamps, lumbar support, security alarm, auto dimming rear view, fold flat load floor, chrome clad wheels, etra power outlet, power seats, glove box light,ash tray light,cup holder light, hood insulation

The professional book says 10.5 hours for a professional to do it. Double or tripple that for the amatuer like me. Been at it for a week with 8 hrs on Saturday, 2 on Monday, 2 on Tuesday. Pulling this Saturday. Hardest part was the fan clutch. Use a peice of metal or board and make a jig to hold water pump pully still to unbolt the nut. Every thing else is going fine so far.