Dodge Sprinter Van

see link below

under the battery tray

To replace the water pump on a 2005 Dodge Sprinter with a 2.7L engine, first disconnect the negative battery terminal and drain the coolant. Remove the serpentine belt, and then detach any components obstructing access to the water pump, such as the engine cover and timing belt if necessary. Unscrew the water pump mounting bolts and carefully remove the old pump, then clean the mounting surface, install the new pump with a new gasket, and reassemble all components in reverse order. Finally, refill the coolant and check for leaks before starting the engine.

To replace the starter in a Dodge Sprinter, first disconnect the battery to ensure safety. Remove any necessary components obstructing access to the starter, such as the air intake or engine cover. Unbolt the starter from its mount, disconnect the electrical connections, and then install the new starter by reversing the process: reconnect the electrical connections, secure it in place, and reassemble any removed parts. Finally, reconnect the battery and test the starter to ensure proper functionality.

The cost of a replacement key for a Dodge Sprinter typically ranges from $150 to $300, depending on the key type and whether it requires programming. If you go through a dealership, the price may be on the higher end, while automotive locksmiths may offer more competitive rates. It's advisable to check with your local dealership or locksmith for specific pricing.

To change the front side lights on a Mercedes Sprinter van, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the headlight assembly; you may need to remove a cover or panel. Disconnect the electrical connector from the bulb, then twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, reinsert the socket, and reconnect the electrical connector before testing the light.

Sprinter vans typically come with wheel sizes ranging from 16 to 19 inches in diameter, depending on the model and configuration. The standard stud pattern for most Sprinter vans is 5 bolts with a 130 mm pitch circle diameter (PCD). It's important to verify the specific requirements for your particular model, as variations may exist based on the year and type of van.

There are two special tools that look like keys that are inserted to release locking tabs.

You need to program the antitheft code into it. The code should be on a business card in the glove box, if not call your dealer with the vin number.

You can't. the governor is part of the computer programming.

The ignition will not turn on until there is sufficient voltage to run the computers. You may need to leave the cables on longer, or replace the battery.

0w40 synthetic or 15w40 conventional.

The wiper motor is pulling too much power for some reason, or the cabling is damaged, causing a short to the chassis.

5w30 or 5w40 synthetic diesel engine oil