Lexus GS

The dealer is offering a "plug-and-play" solution. No wiring headaches or compatibility issues, etc. Talk to a good mobile sound system sales and installation pro and see what else is out there. There are too many options to list. With the dealer, you're upgrading. With any after-market shop, no matter how good they are, you're basically "junking out" the current system and starting over. It won't be cheap.

Go to Toyota dealer and get 3 quarts of ATF type IV. It cost around $6 a quart and also order 1 automatic plug washer.

600 dollars. trust me i know from personal experience. and Lexus will only replace not repair hope this helps :)

You can purchase the KIT which usually has a small gage and a special hose that will ONLY fit on the LOW side pressure fitting and the instructions of which tell you how to read the gage in order to determine how MUCH FREON to add to the system.

Check battery connecters to see if they are tiightly connected. I had that some problem and it was the old battery connecters that where loose. I brought some new connecters and had the mechanic put them on. never had a battery problem even sense.

Unlock the drivers side door with the key and this will disable the alarm. Lock it with the key when you leave and the alarm will turn back on.

Assuming factory alarm with no modifications.

There are two fuse boxes located in the 1993 GS300...on the US Spec Gs300, 1 fuse box is located under the hood on the right area facing side. The other is located underneath the dash, above the brake pedal, on the driver side.

The Lexas GS 300 is a first generation model of car sold by Lexas which is a division of Toyota. Production of the Lexus GS 300 first began in 1993 on the 22nd of February.

It is either the drain line below the air conditioner condenser or a leaky heater core. If the water is cold it is the drain line. If the water is warm and sweet smelling it is the heater core.

I have a 1998 Lexus GS300 so I am assuming the process will be similar. I recently changed my cabin air filter due to musty smells in the cabin interior. You gain access to the filter through the glove compartment. Under the section where the CD changer is, there should be a plastic piece towards the back of the glove box where it looks like it connects to the car. This piece should slide off if you push in and then up. Once that is off, there is another plastic door that will be exposed that also slides off, but take a little bit more pressure. It will come off, you won't break it. Once that is off, then you will see a tray that slides out of the compartment and this contains your air filter. Remove the old filter and put the new one in, then repeat the above steps in reverse. Hope this helped you.

120mph

Find your bonnet (hood) release catch below the steering column.Go two inches to the right of this and about one inch down, and now you are at a small black plastic cover with OBDII written on it.Remove this cover,and there's your DLC (OBD port)!

the radio is below the center of the windshield, right below the air vents... If you mean how do you REMOVE the radio then that's another question altogether. PULL out center air vents, REMOVE ashtray, there are 2 bolts there and 2 where you removed the air vent. Remove those and your there.

I have a 99 GS300 and there is a lock on the left side, right above your knee that you can puch in. This will make it so the truck can not be opened, except with a key. You also need the main key to unlock the button, the valet key will not work in this lock. I hope this is helpful.

First, slow down to the speed limit. Have a mechanic check that your tires are balanced and are in good shape. In addition, make sure that your shocks and struts do not need replacing. In this age of a car, it may be that they are failing.

get the Schley tool that holds the crank. use a good 1/2" breaker bar to hold the Schley and a 3/4" breaker bar with 22mm socket to loosen the nut

If it comes on it means the temperature of your engine is too hot. Your engine is overheating.

Every 90,000 miles

Depends. Light cycles on when traction control is activated due to road conditions causing rear wheels to slip. However, If check engine light is also on... there is a malfunction that can be located by checking ecu error codes.

to replace front rotors first remove two bolts that hold on the caliper. use a piece of wire to tie it to the upper strut do NOT let it hang! then remove two bolts that hold on the caliper tray i think they are 17 mm you will need a breaker bar to do this. then take off the rotor sometimes they are rusted so have some penetrating oil and a hammer or rubber mallet to smack them loose.

5.7 qts with filter, look in your manual. I was shocked to find this out and made sure the mechanic I use was aware, he went to LEXUS web site and found same answer.

The 2000 Lexus GS300 wiper blade sizes are 24" drivers and 20" passenger side wiper blades. See Sources and Related Links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only. Be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.

i have a 2001 gs300 and got a estimate of $1,000.00 from a local repair shop--being handy i researched buying one on line for about $300.00 ang replaced it myself--the biggest problem was cutting the flange bolts connecting the conveerter to the extention exhaust pipe

The air filter is inside the black box behind the battery on the driver's side of the engine bay. There are two 10 millimeter bolts on the airbox that hold it closed.

why they is considerable organizational resistance to the introduction of information system