Lexus IS

there are 3 fuse boxes on these cars 1 on right hand side kick panel side of foot well, the other on left hand side kick panel of foot well. the third is in engine bay on passengers side.

It's actually not as difficult as it seems. Look in the fender liner area (where the wheel wheel is) and you will see the screws that hold the liner in place. Once you remove the bottom screws (or be it the screws that hold the edges of the fender liner), you can carefully pull it back a bit to expose the bulb and socket. To remove the socket turn it counter clockwise until you can pull it out. To reinstall the socket turn it clockwise until it locks in place Carefully remove the bulb from the socket and replace with same type. To remove the bulb pull it straight out. Push the new bulb straight in. The bulb is a 194 5w bulb. Note: most of the time the reason the bulbs are burning out in the bumper is due to water getting in behind the lens and not being able to drain. What I have done is use a Dremmel tool to carfully drill a very small hole along the bottom of the lens to allow the water to drain. Another option is if you have clear silicone you can suirt some around the outside of the lens. This will prevent water from getting in. However, if there is already water in the lens you will have to drain the water first. To drain the water use a ratchet wrench and unscrew the nut that holds the lens to the bumper. In severe cases of corroded sockets you might have to replace the socket where the bulb goes into.

1- take bumper cover off. 2-disconnect bolts from behind headlight assembly in engine compartment and from inside of wheel well to assembly. 3-twist cap rear cap off, flip clips holding lamp assembly in place, and pull out lamp. 4-im still learning how to check the ballst.

There is one fuse panel next to the dead pedal on the drivers side of course and there is also one right in front of the battery under the hood. Replacing the fuses under the hood can be very tricky. See your local dealers parts guy for instructions on how to replace these fuses because most of them don't just pull out.

If you remove the small plastic protection cover just in front of the engine sump it is held on by 3 10mm screws. you will find the oil filter housing, you will need a special tool wrench to remove the housing cover these can be purchased on E-Bay. Goodluck because its really a tight fit.

The 2008 Lexus IS-350 has a V6 engine.

No. They came as sedans and as a 5 door wagon called the Sportcross.

The 2011 Lexus IS-350 has a drag coefficient of 0.28 Cd.

Purchase a Purolator Cabin Filter. It comes with complete instructions.

Drain all of the gasoline from the fuel tank and replace it with fresh stuff. Then replace the spark plug, which will be no good anymore. After repriming the fuel lines, it should work fine. You can verify that you have water in your fuel tank by pouring some into a translucent container and letting it sit for a few minutes. There will be two layers if you have water mixed in with your gasoline. The gas will float to the top and the water will settle to the bottom. To avoid this problem in the future, always fill the gas tank and gas can after each use and keep the gas can off the ground. Inexpensive gas can also be contaminated with water. What usually happens is that warm air enters the fuel can and when the air cools (at night, for instance), the water vapor from the air condenses out in the fuel tank or gas can. This is more of a problem on humid days.

In the ES250 model, the fuses are located in 2 primary places. In the engine compartment, on the drivers side, along the top outside wall, in a black compartment. Just pop open the snap on hinge to gain access to these fuses. Secondly, inside the car, drivers side floor panel area. Remove panel door to access these fuses.

The 2014 Lexus IS-350 has a V6 engine.

Add fuel to the gastank.

Basic turbo kits cost around $3000 just for the parts. Labor to install is astronomical as well.

it is located on the air filter hose secured with 2 hex screws. cant miss it

How do you remove gas cap for 2004 Lexus RX 330?

The EPA range estimate for the 2013 Lexus IS-250 is 359.1 mi. in the city, 513.0 mi. on the highway.

The 2013 Lexus IS-350 runs on premium unleaded (required).

Because those systems are malfunctioning. They are very important for the safe operation of the vehicle. I highly recommend you take it to a service center and get the issue fixed.

The 2007 Lexus IS-250 has a drag coefficient of 0.28 Cd.

Part if the door handle pops off. Look under the dirt Handel and you should see it. Then use the key from the remote.

For the 2000-GS300 you will need #000 Philips screwdriver, remove the small screw and pry the case open nearest the screw hole. The upper portion of the case has a strong snap like hook that holds it together. Its pretty hefty and seems to be the only way to open it. Inside you will find a module about the size of a quarter that has two more #000 Philips screws securing it. Remove them and under that cover you will find a CR1616 battery. Use a small flat blade screwdriver to lift the free edge of the battery and slide it out away from the retaining tabs.

For a Lexus IS 250 /AWD Key-less Entry Key FOB 2006 and newer:

1. Take out the mechanical key from your fob.

2. Put a flat head screwdriver into the inset space...just inside of the mechanical key slot....and gently turn/pry it. This will pry open the fob.

3. Remove the old battery and replace with a new Panasonic CR1632 battery..positive side facing up.

4. Replace the cover of the fob by first pressing on the bottom then the top (The top is the side where the mechanical key is inserted)

The ground clearance of the 2008 Lexus IS-350 is 0 ft. 5.7 in. (5.7 in.).

Get it serviced

It is 6.9 seconds, which is relatively slow for it's class.