0
Oldsmobile Ninety-Eight
The Oldsmobile Ninety-Eight (98) was a full-size automobile manufactured by General Motors from 1941 to 1996. This model featured the highest-grade exterior and interior trim, as well as the Twilight Sentinel.
412 Questions
Standard engine for Oldsmobile 98 for 1983?
Every 1980 through 1984 Oldsmobile Ninety-Eight had a 5 liter (307 cu. in. Oldsmobile) V-8 with Rochester QuadraJet (4 barrel) carb.
1994 olds 98 3800 engine ABS Speed Sensor location?
The ABS sensors are in each wheel - in the hub assemblies, they are not in the engine.
Why does a 1990 Oldsmobile Ninety Eight die at stop lights but starts back up so far?
Spark plug wires. spark plugs or fuel filter. Check and rpplace them in that order. Usually only spark plug wires need replacing.
How can i change the Engine Coolant Temp Sensor in my 89 olds?
it is located near the end of top radiator hose and thermostat. unplug the two wire connector, and use a 3/4" deep well socket to and to install new. Be Blessed
Where is the starter located on a 1994 Oldsmobile 98?
take off plastic shield that goes from bottom of radiator to bottom of motor and you will see starter in bottom of motor
Why is your fan not working when defroster is on?
most likely your air conditioner needs recharged per my mechanic brother-in-law
How do you fix blinkers on Oldsmobile eighty eight?
First you have to check your flasher, this is located where the fuse box is, this could be one of your problems.
Where is the Oxygen sensor on a 1989 Oldsmobile 98?
Screwed into the exhaust manifold.
Screwed into the exhaust manifold.
How do you repair a hood latch on a 1989 Olds 98?
Often with wear and time, the big spring in the front of the hood will get too compressed to force the hood open when the latch is pulled inside the car. Expand the hood spring by pulling on it or take it off and expand it.
How do you replace the guide block on the window track of an 1986 Olds 98?
I dont know if this will help or not, but on a 86 buick I had we just jurker the window out of alignment and snaped a new plastic glide in place, then pushed it back into its track, its be fine sence. Good luck
