0
Peugeot 306
The 306 was a front-engine, front-wheel drive compact family vehicle manufactured by the French automaker Peugeot from 1993 to 2002. The vehicle was released in three- or five-door hatchback, four-door saloon, five-door estate and two-door cabriolet body styles.
620 Questions
How do you replace the bulbs in the clock of a 1999 Peugeot 306?
remove lower plastic panel covering clock, hazards etc carefully with flat butternife type instrament (not to mark plastic to reveal 2 torx screws remove these, undo wiring connector twist the 2 black bulb holders from the back and replace bulbs reffiting is reverse of removal
How do you remove speedo head from peugeot 306?
To remove the speedometer head from a Peugeot 306, first disconnect the car battery to ensure safety. Then, carefully remove the dashboard trim surrounding the instrument cluster, which may involve unscrewing screws and gently prying off clips. Once the trim is off, unscrew the instrument cluster from its mount and carefully pull it out to access the speedometer head. Finally, disconnect the electrical connectors and any cables attached to the speedometer before fully removing it.
How do you adjust a peugot 306 headlight?
To adjust the headlights on a Peugeot 306, park the vehicle on a level surface facing a wall about 10-15 feet away. Turn on the headlights and mark the center of the beam on the wall with tape. Use a screwdriver to adjust the vertical and horizontal screws located on the headlight assembly until the beam aligns with the marked points. Make sure to check both headlights to ensure they are properly aligned.
What temperature should your peugeot 207 run at?
The Peugeot 207 typically operates best at a temperature range of 90 to 100 degrees Celsius (194 to 212 degrees Fahrenheit) when the engine is at normal operating conditions. If the temperature gauge indicates significantly higher or lower temperatures, it may signal a cooling system issue or a malfunctioning thermostat. Regular maintenance and monitoring of the coolant levels can help ensure the engine runs efficiently within this temperature range. Always refer to the owner’s manual for specific guidelines related to your model.
How remove gearbox on Peugeot 306 hdi?
To remove the gearbox from a Peugeot 306 HDi, first ensure the vehicle is securely lifted and supported. Disconnect the battery, then remove the driveshafts by unbolting them from the gearbox and hubs. Next, detach any electrical connectors, the clutch cable, and the gear linkage. Finally, unbolt the gearbox from the engine and carefully slide it out, making sure to support it properly during removal.
How do you remove the inner tie rod from a Peugeot 306?
To remove the inner tie rod from a Peugeot 306, first, ensure the vehicle is securely lifted and supported. Disconnect the outer tie rod from the steering knuckle, then use a tie rod end puller if necessary. Next, unscrew the inner tie rod from the steering rack using a suitable wrench or tie rod tool. Finally, ensure to replace any worn components and reassemble everything securely.
