Volume

2.5 cubic feet, as per the product manual.

Remember K H D | d c m (kilo, hecto, deka, (liter, meter, gram), deci, centi, milli). Milliliters are three places to the right of liters. So you have to move the decimal place three times to the right. You will get .65 L = 650 mL.

To convert standard cubic meters per hour (SCMH) to actual cubic meters per hour (ACMH), you need to multiply by the gas correction factor (H factor) according to the gas being measured. The formula to convert SCMH to ACMH is: ACMH = SCMH x H factor. The H factor varies depending on the specific gas composition you are dealing with.

10 mL - A cc (cubic centimeter) and a mL (milliliter) are equal to each other in terms of volume.

The troy ounce supposedly got its name during the Middle Ages for an annual fair held in Troyes, France. A troy ounce weight is equal to about 1.1 avoirdupois ounces, 480 grains, or 31.04 grams.

There are 2.125 quarts per 68 fluid ounces.

Square feet and a cord of wood are different types of measurement: square feet is length x width; a cord of wood is volume - length x width x height. A cord is the amount of wood is 128 cubic feet, or 4 feet wide, 4 feet high, and 8 feet long.

The formula for volume (cubic dimension) is V = L x W x H: 14 x 8 x 2 = 224 cu ft

The cost of dirt per cubic foot can vary depending on factors such as quality, location, and quantity purchased. On average, you can expect to pay anywhere from $10 to $50 per cubic foot of dirt. It is best to check with local suppliers for specific pricing in your area.

64 US fluid ounces = 1.89 liters.

Steel pipe is made by pulling the molten steel through a cone before its welded together. Twenty one feet is the length at which the newly formed steel would hold a straight seam wield but still be able to be formed into pipes.

It really depends on how big the sink is.
Well how big is your sink ?

0.5 liters is equal to approximately 16.91 fluid ounces.

0.81 gal

1 gallon makes 128 ounces and 1 ounce is 0.0078 gallon in U.S measure. There are 8 ounces in a cup, 2 cups in a pint, 2 pints in a quart and 4 quarts in a gallon. That makes 128 ounces in a gallon US. In UK 20 ounces to the pint, 8 pints to the gallon which makes 160 ounces Imperial measure.

The weight of a 50% solution of caustic soda would be approximately 9.21 pounds per gallon.

Method 1:

Fill the 3-gallon jug.

Pour this into the 5-gallon jug.

Fill the 3-gallon jug again, and pour from it into the 5-gallon jug until it is full. This leaves 1 gallon in the 3-gallon jug.

Empty the 5-gallon jug, and then pour the gallon from the 3-gallon jug into it. Fill the 3-gallon jug, and pour it into the 5-gallon jug, thus making 4 gallons.

Method 2:

Fill the 5-gallon jug.

Pour this into the 3-gallon jug until it's full.

Empty the 3-gallon jug, and then pour the remaining two gallons into the 3-gallon jug.

Fill the 5-gallon jug, and then pour into the 3-gallon jug until it is full, leaving 4 gallons in the 5-gallon jug.

It depends on what the soil contains. It may contain sand or gravel. It may contain water. It may contain little or much organic material. It may be highly or loosely compacted. On the average, however, the density of ideal topsoil is about 1.25 grams per cubic centimeter, or about 78 pounds per cubic foot.

Personally, what I would do would be to experimentally find a lead fishing sinker,

rock, gold coin etc., which, when added to the irregular object, sinks them both.

For accuracy, the object selected should be smaller than the irregular object.

The smaller, the better.

Then, in the usual way, find the volume of the sinker, the rock, or the gold coin alone.

Write it down so I don't forget it.

Finally, glue the 'ballast' to the irregular object, and measure the volume of the

combination by sinking it. From the volume I find, subtract the volume of the

ballast alone, and I'll have the volume of the irregular object.

One cubic foot contains about 7.48052 US gallons or 6.229 Imperial gallons.

From: http://www.windows.ucar.edu/tour/link=/comets/tail.html&edu=high :

One tail is due to the comet's dust particles, the other is due to ionized gas from the comet coma.

Dust particles form the first tail. The only force which affects these small particles in space is corpuscular radiation from the Sun itself. This radiation pushes the tiny dust particles in the direction from which they came, the way wind can blow rain droplets at an angle. Cometary dust particles can be thought of as billowing up from the comet's surface. Thus, this comet tail generally points back along the comet trajectory.

Ions (electrically charged particles), which first come from the nucleus as (neutral) gaseous particles, are swept into the second comet tail by interaction with the Interplanetary Magnetic Field (IMF). The IMF, or magnetic field of the sun, which is present everywhere in interplanetary space, sweeps past the comet nucleus and carries the ions with it to form the tail. Because of this special interaction with the IMF, this tail always points directly away from the Sun"

There are 29.57milliliters in 1 fluid ounce.

0.23 liters is 7.8 (7.777225) US fluid ounces.