the answer is the same as the 1967 dodge dart grille i already posted but be carefull the plastic will break
remove grill,remove bumper,unbolt fender bracket off bumper bracket,take off splash pan in between door and fender,take out fender bolts,don't forget bolts on bottom of fender.there is a bolt under the fender ,back by the door at the top.pull fender off.good luck.
The 2013 Dodge Dart has 42.2 in. of front leg room.
What engine??? Standard V8 is 1-8-4-3-6-5-7-2 and the distriburator rotates counter clockwise.
You will need a Philips screw driver a #2 0r #3 there are about 4 of these screws. This will remove the chrome potion of the grill. Behind the chrome you will find some brackets. If you want to remove more than the chrome part such as the brackets be carefull as the airconditioing evaporator is behind the grill. This will be nessasary also if you have to remove the radiator. The brackett at the top that goes from the left to right side over the top of the radiator will have to be removed if you want to remove more than just the chrome portion of the grill. There will be 6 bolts I belive as well as 2 nuts that will have to be removed. 2 of these are hidden under the seal that the hood closes against, they will be at the outer ends.
A 'Swinging Couple' or 'Swinger' is a person or couple who has an understanding with their partner to have relations outside of their 1 on 1 relationship.
51.53 inches from u-joint center to u-joint center
There is a ring that you must tap off in a counterclockwise motion. The sending unit will easily be removed. My 65 GT got a new tank and sending unit replaced in under 2 hours. Getting the tank off was somewhat harder to do because of the rubber boot that connects it to the gas neck. One strap bolt and some wiggleing and off it came. If your gas gague is broken your voltage limiter may be failing under the dash. If your temp gague and gas gague both are not working that is likely the cause. It gets worse. If the voltage limiter is bad there is a good chance that the gagues are ruined... Dodge may have all the parts for about 150 bucks. All the best.
1 - 5 - 3 - 6 - 2 - 4
The distributor rotor turns CLOCKWISE
The marked # position on the distributor cap faces AWAY from the engine
The engine cylinders are numbered 1 to 6 , from front to rear
Look in or near the fuse box - driver's side firewall area
The gas tank on the 2013 Dodge Dart holds 15.8 gal..
1970-72 Dart, except the side marker light is in a different location on the 72
what about the fuse box?, more info needed.
more than likely you need a new radiator for it, when you install it back flush the engine.
70,00
The price for a Dodge Dart varies greatly by location. The average cost for a base model (without the extra features) is 16, 913$. Price does vary by state.
The Dodge Dart either came with a 6-cylinder (referred to as a Slant Six) or 8-cylinder (V8) engine. This is, of course referring to the Dart of the sixties and seventies, NOT the ones that have been recently released by Dodge.
17 years of production, that was way back then though. Look up how many cars can be made in a year, multiply it by seventeen, and divide it by 3 and take the decimal away, round it up. Thats your answer. Divide it by three because in present day we no longer have car assembly lines, we have automated machines.
It all depended on what engine was in the dart, there were 2 differen't trannies.
My '72 manual says to use DEXRON auto trans fluid in a 4-speed. It also notes that if objectional gear rattle at idle is apparent, the trans can be filled with Multi-Purpose Gear Lubricant SAE 140.
haynes repair manuals at napa auto parts stores.
there are 2 clamps that have to be dislodged on the seat bottom and there is one on each side of the base of the seat, push the base of the seat inward and then push up to dislodge the clamps, this has to be done on both sides of the seat bottom, once you get the seat bottom out you will see 2 bolts that hold the seat back rest in place, take the 2 bolts out and then you will be able to take the seat back out.
well a 75 dodge dart wieghs 3680 pounds there about the same i guess i had mine wieghd at the truck scales
if it has the 4.5 lug pattern- large bolt pattern and you have a 15 inch wheel
I don't think so, I think the K-frame has to be changed to go to a V8, you could always use motor plates to install it.