0
Infiniti J30
Known as the Nissan Leopard J Ferie in Japan, the Infiniti J30 was a mid-size luxury car produced between 1992 and 1997. This rear-wheel drive, 4-door sedan featured a 3.0 L VG30DE V6 engine and 4-speed automatic transmission.
500 Questions
How do you replace an ignition switch in a 1993 infinity J30?
Asked by Wiki User
step 1 disconnect wires .step 2. take 2 screws off the old one .step 3 pull the ignition coil out. step 4 put new one in. step 5 put 2 screws back into place. step 6 connect wire ..repeat steps 1 -6 for next coil... any questions
Where do you plug the code reader in on a 94 Lincoln Mark VIII?
Asked by Wiki User
Under the hood on either side right by the shoch tower
Where is the Location of 1994 infiniti j30 signal light relay?
Asked by Wiki User
Behind the instrument cluster on the steering column.Not visible from below you have to rtemove the cluster entirely to even get to it.It is small and a black box.And no parts store stock it Order only item.Hope this helped.
Where to plug in code reader for infinity?
Asked by Wiki User
The plug for the computer is under the dash on the driver's side.
What might cause noises coming from the undercarriage of the car?
Asked by Wiki User
a mechanic heard a rattling under my 95 and said it was a small hole in my muffler pipe and it will get bigger if i dont weld it but someone else said the pipe was loose and knocking on the clamp
50k ago, I had to remove the heat shields from the catalytic converters. Took care of it!
What is obd code p0443?
Asked by Wiki User
The P0443 code translates to: "Evaporative Emission Control System Purge Control Valve Circuit". To find more information on this code, go here: http://www.obd-codes.com/p0443 For a complete list of codes, go here: http://www.obd-codes.com/trouble_codes/
Where is the thermostat located at on a 1994 Infinity J30?
Asked by Wiki User
It's hard to reach. You need a 12mm socket and a metric Allen wrench set that's somewhat long. I just replaced mine. It was difficult. Remove the fan. Remove the air inductions. I took off the alternator belt too. Some of those bolts were practically seized in there. Using anti-seize paste is recommended on reinstallation. You don't have to remove the water pump. The themostat is above the pump, at about two o'clock. I used a backflush kit too to clean the system out. Those kits are at all auto part stores. Prestone makes them.
AND DON'T DUMP THE ANTIFREEZE!! IT'S HIGHLY TOXIC. Ethylene Glycol breaks down into formaldehyde. It's sweet. Pets drink it and die of kidney failure. It takes only a teaspoon. Service stations that have a garage are required by law to accept your antifreeze. They will want to know that there's no other garbage in it, though, (like oil).
Most are located in a removable housing at the engine end of the upper radiator hose
What does the A T Check light flashing on your J30 mean?
Asked by Wiki User
The blinking light indicates that it is time for a check-up. The cimputer automatically does this upon hitting a specific mileage. I am suffering from the same thing with my J30. When I find the reset button, I'll update this section.
What is the difference between 91 octane and 95 octane?
Asked by Wiki User
91 octane petrol will ignite at a lower temperature and burn faster, which can cause knocking in an auto engine. Lead compounds were added at one time to raise the octane rating, but recently engines have been redesigned to work on low (<98) octane petrol (or gas in the US colonies)
What are the 3 belts in the infiniti j30?
Asked by Wiki User
You have an Air Conditioner, Power Steering, and Alternator/Water Pump belt.
Why does a abs light go off?
Asked by Wiki User
because you have a problem with your Anti-lock Brake System (ABS)
this sometimes occurs when you have come to a sudden stop (thereby engaging the abs) it will usually go off again after you restart your car. IF IT DOESNT GO OFF BY ITSELF, GET IT CHECKED OUT!!!! by a professional
Why does a 1995 Infiniti J30 stall after accelerating from stop when you AC is on?
Asked by Anton06
need to set base idle and clean fuel injectors
Why does a 1993 Infinity J30 shake after replacing all the plugs?
Asked by Wiki User
J30's don't have a distributor. Each cylinder has its own ignition coil controlled from the engine computer.
It sounds like it is misfiring as one of the cylinders is now no longer reaching ignition.
I'd say double check the connections. Push on each plug to make sure they are completely engaged. I am talking about the power source to the coil.
Hopefully, you didn't overtorque the plugs and strip the cylinder head sparkplug sockets. Only about 15-18 ft./lbs. are needed.
It is possible that the wires from the distributor were not replaced to their corresponding spark plugs. Did you use the correct replacement plugs? The J30 requires platinum-tipped spark plugs.
How do you install a alternator on a Infiniti J30?
Asked by Wiki User
How to Change an Alternator: Video Series check related link below
What could cause 1995 J30 to overheat and run hot?
Asked by Wiki User
Check the simple things first. With your engine COLD, open the radiator cap and check to see if there's coolant filled all the way to the bottom of the neck. If you look inside and see the slots inside your radiator, then you need to add a 50/50 dilution of coolant (purge). If it's full, then your problem may just be the thermostat (widely available). If that part is okay, you might need a new water pump (overheating problems are so much fun to troubleshoot). Other causes are blocked radiator tines (from bugs and leaves and other road junk), your timing is too far advanced (your spark plugs will tell you for sure), or you may have far more serious problems (warped heads, blown head gasket (check for water or sludge on your oil dipstick). Good luck. Steven
