ok on the s 10 blazer you wil first have to disconect the neg batt. cable from batt. then if you have a 4x4 you will have to remove the skid plate then the cross member. then the starter brace and shield if ya have one then you should see 2 bolts. clean wires that are attached to starter make note where they were. tape the ones that are one each post that go together then remove wires. then remove the 2 bolts tghat hold the starter to eng. note if you are going to all this trouble it would be a good idea to go ahead and replace the main wire to the starter.
make sure you have the starter tested before getting a new one i had the same trouble on my blazer i replaced every thing i could think of i had to have it towed to a shop and the found out it was the wiring harness that runs under the washer fulid tank it was bad they told me it was a bad design on the maker of the s 10
on mine i replaced the batt. the starter the the nutral safety switch the batt cables pos and neg. hope this helps if you need any more help you can email me at braddonovan29@Yahoo.com i have the total break douwn book on that tat blazer. i sold my blazer but i still have the book you can get one from a auto parts store. for about 15 bucks.
There is no adjustment required, but you can clean it with a carb cleaner.
It should be on the front of the intake manifold directly above and behind the water pump.
sounds like a vacuum leak
.043
.43L. 1000ml=1L
Use an exhaust made for an LT1 engine the blocks are identical it is the insides that is different. Will bolt right on.
4L60/E l
Yes it will bolt right up to it.
43L of 18-k gold
E`bay --Ebay motors ,,search chevy, blazer s10, I have found and seen motors as low as 600.00, for blazers,If you can`t find it let me know and i`ll find the e`bay store and let you khow what it is.. Jasper engines are the best rebuit engines that I have seen and have a backed up warranty. I'm sure there is a dealer near you that installs them.
There is one before and one after the catalytic converter.
The fuel lines around the filter; you will need an adapter.