There are two sets of pins in each side of vehicle, one set on top of brake pads and one on bottom. All you need to do is push/pull the pins out with large screw driver.
You can use a large "C" clamp to compress the piston to aid in removing the pads. I would recomend taking the cover off the master cylinder reservoir (where you add brake fluid) to make it easier to compress the piston. Then, follow the advice above to remove the pins. They are two triangular shaped metal pieces with a material, similar to silicon, between them.
how to change front brake pads on a 1994 lexus es300
What size is the steel brake line tubing on a 1994 Ford Ranger
are there struts or shocks on the front of a 1994 ford ranger 2wd
The brake fluid used is DOT 3
how do you change tail light cover on a 1994 ford ranger
Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.
The front wheels on a 1994 Ford Ranger lean inward due to the camber of the steering alignment. Adjustments can be made at a local tire shop.
yes it is very easy
How do you change front tire studs on a 1994 Seville sts
Pull the tires off and take the brake calipers off and the rotors will pull off.
Lug wrench, metric socket set, "C" clamp
I had this problem before on a ranger you have to pull the dash board out and it will be right there.
First off check ur brakes in front but with e-brake causing it to glow brighter then most likely check the back brakes. ANSWER Check your brake fluid level in the brake master cylinder in your engine compartment . The brake light comes on when your brake fluid level is low , or your emergency brake is on.
On a 1994 Ford Ranger , 3.0 and 4.0 V6 engines : firewall 3 - 6 2 - 5 1 - 4 front of vehicle
On a 1994 Ford Ranger : Check in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump I believe that is where the fuel pump inertia switch is on a 1994 Ford Explorer
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
Remove the tire and wheel from your 1994 Chevy. Remove the brake assembly. Tap on the rotors with a hammer or mallet. The rotors will slide off. Reverse the process to install the new rotors.
right behind the motor an in front of the transmission its where they meet
how to change the brakes
On all Harleys with disc brakes the front brake switch is located inside the right handlebar switchbox.
Pads on front. Drums on the rear.