How do you remove a transfer case?

How do you remove the transfer case from the transmission in a 1996 Chevy blazer 4x4?

Remove all wires attached to the transfer case. Remove the driveshafts. Drain the fluid out of the transfer case. Place a transmission jack under the transfer case. Unbolt the transfer case from the transmission. Unbolt the crossmember the transfer case rests on.

Do you have to remove a transfer case when installing a transmission?

Yes you will have to remove the transfur case first.

How do you remove a 1999 Ranger transfer case shift motor?

How to peplace A RANGER transfer case SHIFT MOTOR

How do you replace a transfer case motor in a Ford F-250?

How to remove a transfer case in a 97 f-250

Where is transfer case plug on a 2001 dodge 3500?

It is on the back of the transfer case, takes a 10mm Allen wrench to remove.

How hard is it to change the transfer case on 1997 EB expedition?

Not hard at all Remove drive shafts Remove vent tube Remove connector Slide transmission jack under transfer case Remove mount bolts and your done

How do you check transfer case fluid on a 98 discovery?

Remove the fill plug on the transfer case and see if fluid is up to the edge of the plug!

Does the fluid from the trnsmission an transfer case mix in the Chevy 1 ton?

NO. If you keep finding yourself ADDING transmission fluid often and you have no leaks but the transfer case is over full then you need to remove the transfer case and replace the seal in the transfer case where it bolts to the rear of the transmission.

How do you remove 88 Chevy transfer case shift knob?

twist it off

How do you replace transfer case on 2005 silverado?

Remove the transfer case shield, if equipped.Drain the transfer case of fluid.Remove the front propeller shaft.Remove the rear propeller shaft.Remove the transmission shift control cable clip from the transfer case.Remove the transmission vent hose clip from the bracket, if equipped.Disconnect the speed sensor electrical connector. Disconnect the inline to engine harness electrical connector. Remove the inline connector from the harness bracket.Disconnect the encoder motor electrical connector. Remove the clips from the transfer case brackets.Disconnect the transfer case vent hose.Support the transmission with a suitable transmission jack stand.Remove the transmission mount nuts.Remove the crossmember bolts.Remove the crossmember.Remove the transmission mount boltsRemove the transmission mount from the adapter.Support the transfer case with a suitable jack stand.Remove the transfer case adapter nuts.Remove the harness bracket. Important: The following service procedure must be performed with the assistance from another technician.Remove the transfer case, perform the following:Slide the transfer case straight back toward the rear of the vehicle.Rotate the transfer case so that the front output shaft is above the torsion bar bracket.Rotate the transfer case (with the input shaft slightly lowered) so that the transfer case is parallel to the torsion bar bracket.Lower the transfer case.

What kind of transfer case fluid is used in a 1999 GM Safari and where to put the fluid in the case?

It uses Trak II transfer case fluid, GM part number 12378508. The fluid goes in a hole, use a ratchet with an extension to remove it, on the side of the transfer case.

How do you get the cross member holding your transfer case off?

remove the bolts at the frame rails