answersLogoWhite

0


Best Answer

On the left and right sides of the steering wheel are small rectangular or similarly shaped plastic covers. Pry them out ro remove and this reveals the screws (usually torx screws). Remove these and the entire steering wheel air bag will come out as one peice after disconnecting the wire harness. remove the steering wheel center nut then twist the wheel left and right to free it from the shaft (before sliding it off mark its location on the shaft so the wheel ends up straight again!) Pay attention to how the wires are oriented while slowly removing the air bag assembly and re-install exactly without pinching any wires. There are also the plastic top and bottom half covers between the instrument panel and wheel (the steering column) that have to come off. These hides what you are replacing. 1 screw is accessible from underneath the bottom half cover, the other 2 face the driver. remove the 4 screws that hold the airbag/horn wiring and slide it off the shaft. there are 3 more screws that hold the switch assy in place, take them out, unplug the plugs on the assembly and the rest is obvious!

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it necessary to dismantle the steering column on a 98 Camry in order to replace the hi-low beam switch?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove and replace a steering column in a 95 Cadillac Sedan Deville?

How to remove and replace a steering column on a 95 Cadillac Sedan Deville?


How do you replace steering column on 1986 Pontiac parisienne?

how to change steering column on 86 pontiac bonneville


Instructions to replace steering column assembly 1995 Monte Carlo?

when do you know when you have a bad steering column


Why is it NECESSARY to remove the steering wheel to replace the ignition switch on a 1994 Ford Explorer?

I was under the impression the switch was on the steering column about 18 inches from the floor. The lock assy is under the steering wheel.


How would you tighten a loose steering column on an Olds Delta 88?

You have to replace the entire steering column. It is not loose, the lock is broken on your column height adjuster.


How do you replace the steering column for a 74 nova?

you simply GET A MECHANIC!!


Can you replace any 89 caprice steering column with another 89 steering column?

A Caprice steering column can be replaced by another as long as it matches. It if comes from another Caprice of that year, it will fit properly.


How do you repair a sloppy shift column on a 1996 Ford F250?

The cheapest and easiest would probably to install a floor shifter. If you don't want to do that, you would have to almost completely dismantle the steering column.


When replacing the heater core on a 1999 Blazer is it necessary to remove the entire steering column surrounding components?

drop the steering column, remove entire dashboard.


What would cause your steering column on a G20 van to become loose?

There are 4 bolts at the bottom of the steering column that tend to get loose after entering and exiting your vehicle. Pulling your self up on the steering wheel puts stress the steering column and causes it to become loose. If you do not correct the problem fast by tightening the bolts you will have to replace the entire steering column.. -Henry's locksmith and steering column repair


Where is the turn signal flasher located on a 89 Chevy Cavalier and do you need special tools to replace?

It's located under the steering column. Remove the trim panel beneath the steering column (3 screws) and gently lower trim piece (it's not necessary to remove). Look for the canister-looking silver flasher to the left of the steering column. It's easy to find. Good luck!


How do you get to the ignition switch to replace it on a 1994 Chevy pickup?

Lower the steering column.