sounds like you put clutch disk in backwards
when you have a clutch put in you also have to replace or remove the flywheel and have it refaced to keep from messing up the new clutch, and yes the flywheel is suspose to turn when the engine is turning, so if the flywheel wasnt replaced or refaced then i would say that the flywheel is what the problem is
bad flywheel can be caused by incorrectly adjusted clutch. in correct use od clutch,9such as riding clutch).can also be caused by a worn clutch not being replaced before it damages flywheel. one other problem with a flywjheel can be the ring gear worn or missing teeth, this is usually caused by a starter motoer being installed that does not match the flywheel properly
If the AC pulley is locking up when the ac compressor clutch engages, it's not a clutch problem, it's a compressor problem. But yes, the AC clutch can usually be replaced separately. The problem is, if the clutch is worn out the compressor is probably worn out as well. It usually isn't that much more to replace the whole thing.
Assuming this is a standard transmission flywheel, if the clutch has been allowed to slip excessively and overheat the flywheel, it may have cracked and warped the flywheel clutch surface allowing the clutch to chatter during take off.
Simply put. when you depress the clutch pedal, it separates the clutch disc from the flywheel, when you let go of your clutch pedal it drops the clutch disc back onto the flywheel. Flywheel- spins at the speed of your engine (RPM) revs per minute depressed clutch-is seperated from flywheel allows you to shift into higher or lower gear released clutch- is engaged onto flywheel the two connect.. engaged clutch means your gonna move! disengaged clutch means you aint moving forward, your literally in neutral.
i have replaced my clutch to 10.5 diemter ,can i re use the morso flywheel/clutch bolts
to remove the clutch from the flywheel u will 9mm 12 point make sure when u put the clutch or flywheel u torgue it down to vw spec.
The Clutch is sandwiched between the pressure plate and the flywheel. The flywheel spins with the crankshaft and the pressure plate presses the clutch disk to the flywheel. The flywheel transmits torque to the transaxle input shaft through splines along the inner hole in the clutch. The clutch is between the engine and the transaxle Dean Schrickel, P.E.
If there is a clunking noise on a 1991 Firebird Formula 5.0 when going below 30 mph, and the clunking noise does not happen when the clutch is depressed, it is probably a problem with the flywheel. The flywheel moves freely when the clutch is depressed. When the clutch is not depressed, it could be that something is rubbing on the flywheel, like the clutch plate.
A spring is used to hold together the clutch and the flywheel.
You don't HAVE to replace the clutch, but, since the clutch has to be removed before the flywheel can come off, it'd be foolish not to. There's a lot of work involved that would have to be duplicated later.
The flywheel just bolts up, remove the bolt.