0
On a 1995 Nissan Pickup, 2.4 liter engine, the crack angle sensor is located on the distributor under the distributor cap. It is regarded as the right hand to the ECCS control unit, as it is the basic signal sensor for the entire ECCS system. It monitors the engine speed, piston position and it sends signals to the ECCS control unit for control of the fuel injection, ignition timing, idle speed, fuel pump operation and the EGR functions.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the crank sensor located on a 1995 Oldsmobile Aurora 4.0?
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
Where is the location of crank sensor for range rover v8 4.6HSE MODEL 1999?
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
Where is the crank position sensor located on a ford 350 xl 5.8 liter?
The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
Where is the crank sensor on a 1997 sonoma 2.2 liter engine located?
The crankshaft sensor is located on the passenger side of the engine, close to the coil pack. It is easier to reach it from under a raised vehicle.
Where is the location of the Crank Sensor on a 3.1 Corsica Engine?
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
Where is the crankshaft position sensor located on a 1997 full size dodge 1500 van with a 3.9 liter engine?
crank sensor is located at the top of the transmission bell housing,two hex bolts that hold the crank sensor in place.
Where is the crank sensor located in the 1996 Chrysler LHS?
the crank sensor is located in the transmission bellhousing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft. one 10 mm bolt holds the sensor in place, this is on the 3.5 liter engine,
Where is the crankshaft position sensor on a 2001 Aztek 3.4 liter?
The crank sensor will be located iether behind the harmonic balancer or right on the side of the engine block
Where is the crank shaft position sensor on a 2.2 liter 1993 Cavalier?
The crankshaft position sensor is located on the rear of the engine. It is mounted just above the oil pan on the engine block.
Where is a camshaft sensor located in a 2001 caravan 2.4 liter?
i think u mean crank sensor and that would be by the dampener or balancer in the front of engine (near crankshaft)
Where is the crank sensor on a 93 Rodeo 3.4L?
You can find the crank sensor on the back of your 1993 3.4 liter engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
Where is the crank sensor located on a 1993 Grand Prix with a 31 Liter engine?
the crank sensor is somtimes located on the top of the oil pan. i know it is atlest on the 91. side of the block just below the exhaust manifold it takes a 10 mm socket
