0
The fuse box is located behind glove box. Open glove box and remove tray inside (no tools, just pulls out). You will find it right away against the firewall. Also look in the lid of glove box and you will find spare fuses and fuse puller. Hope this helps.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the firing order on an 1993 Oldsmobile cutlass supreme 3.4L engine?
"What is the firing order on an 1994 Oldsmobile cutlass supreme 3.4L engine?"
Where is the inertia switch in a 1993 Oldsmobile Cutlass Supreme?
I HAVE A 1992 OLDS CUTLASS SUPREME JUST BE FOR it warm up it cuts off
Where is the AC evaporator located on a 1993 Oldsmobile Cutlass Supreme?
under right side of dash
Where is the Flasher location for a 1993 Oldsmobile?
Which model 1993 Oldsmobile and which flasher relay? Turn signal or hazard relay?Cutlass Supreme and it's the flasher relay
Fuse box 1993 olds cutlass supreme?
Open the glovebox, pull out the black comparment, look down and you will find the fusebox.
Antanna wiring diagram for 1993 Oldsmobile cutlass supreme?
show wire names for car stereo
How do you access the fuel pump on a 1993 Oldsmobile cutlass supreme?
inside gas tank,remove tank.
Why does the automatic locks on my 1993 Oldsmobile cutlass supreme don't work?
More likely than not a blown fuse.
Where is the block heater on a 93 Oldsmobile Cutlass Supreme?
You can find the 1993 Oldsmobile Cutlass block heater on the right hand side of the engine block. You can follow the block heater cord directly to the block heater.
How do you install starter in 1993 cutlass supreme?
Stick the starter in the cutlass supreme.
How do you fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2 door?
To fix the outside door handle on a 1993 Oldsmobile Cutlass Supreme 2-door, remove the trim and access the mounting screws. Remove the nuts and disconnect the linkage rod by flipping the small clip and sliding the rod out of the handle. Reverse procedure for installation.
How do you install a crankshaft sensor on a 1993 Oldsmobile Cutlass Supreme?
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
