the blower motor resistor is about 2 inches closer to the firewall then the bottom bulge of the blower motor . look for a little hex nut .. be carefull tho there is two more bolts on the rear side you will need a flex extension to get to them .. you easiest way is to loosen the back two and take the front one out and you can push it to the side to pull it out
There is a removeable panel below the glovebox. It is in front of the blower motor against the firewall. It has a wire connector from the loom and then it plugs into the blower motor
If you are referring to the blower motor speed, and only the highest setting works, then the problem is a bad Blower Motor Resistor Pack.
Blower Resistor is located near the passenger side floor. There is a black cover over the blower housing. Remove the cover and you should see it. You may need to pull the carpet back to get access to the resistor. Also be sure to have a
Have your blower motor resistor or blower motor checked out
The blower motor resistor assembly is located to the right of the blower motor. The blower motor is located in the engine compartment on the passenger side of the firewall.
heat not working
Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.
you need to repleace the blower motor resistor under the das on the passenger side
Loose connection or blower motor is bad
Should be behind the glove box. The blower motor speed resistor is located under the hood, on the firewall, passenger side, close to the blower motor.
I would look into the blower motor resistor module
right next to the blower unit.