The controller is bad
Maybe, but wiper motors have high and low brushes.
Check fuses, wiring, etc....
If the motor works on high, or any speed, then it's fine. Switches and resistors control speed and delay.
the GEM module located behind the radio. it is a black box with a large connector that control wipers, 4x4 and a few other thing. expensive and fails for no good reson. i have replaced for 4x4 no engaging and wipers too.
drive side wiper does not work
I don't know but i suggest you take the truck in to a shop that specializes in electrical work
Either the fuse is blown or the wiper motor is bad.
You need to replace the wiper motor.
The resitor is probably burnt out on the high mode
possibly the multifunction switch is acting up or just bad
My wipers would only work on high. we replaced the signal lever which works the wipers too. i did get my mechanic to do it because it was'nt as easy as the parts store said it was. try replaceing the wiper pulse relay board under driver side dashboard
most likely the switch is bad, or the wire plug has a bad connection
Multi functions switch is junk
try checking the switch
we have the same problem. let us know when you find the answer
I have a 97 Honda accord that the wipers don't work, they only work when you hold down the mist conroller arm. It has the intermittent controls on the wipers also.
Bad switch? stalk bad wiper motor? bad low speed winding
Windshield wipers don't work
The 1999 Oldsmobile wiper switch can be located below the dashboard. The wiper relay switch simply plugs in and out.