Its honda's F22B1, a 2.2L SOHC (single over head cam) v-tec.

1-3-4-2 as with all I-4 engines

How long can you drive before getting your egr valve repaired on 1999 acura cl?

almost 5 quarts put 4 in the engine check the dipstick clean it and inserted again if the level is under the cross hatch area add more til it reaches the middle of the cross hatch area

You need a head gasket.

You can remove the 2001 Acura spark plugs with a 5/8 deep well socket. Turn the socket to the left to remove the spark plugs. Reverse the process to install the new spark plugs.

Pressure is low for some reason-check your fluid.

The screw is used to adjust the headlight beam. Pull towards a wall, and you can see the beam projection to set the headlights evenly.

You don't need to cut the wires at all, I just got mine installed in 5 minutes with the adapter speaker plug, you can get them from Amazon or eBay for 16 bucks. You save a lot of time and you don't mess up the wire system of your car with the black tape and stuff.

1. Disconnect the negative battery cable.

2. Disconnect the starter electrical connectors.

3. Remove the 2 starter mounting bolts.

4. Remove the starter motor.

5. Installation is the reverse of the removal procedure. Tighten the starter motor bolts to 33 ft. lbs. (44 Nm).