Bridges and Tunnels

The Maxwell Bridge is known as an AC bridge. This bridge is used to find the self inductance and the whole amount of a circuit.

rainbow type, you fine them mostly in unicorn land

actually you know what I don't know the answer, I don't know why they ask me what is the answer since its a website so we should ask them the question but here they are asking the question.

To figer that out, well it is hard. you would have be a geart geomiter or bulider. some steel bridges are pritty old so yeh.

In simple terms, cable stayed use less cables then a suspension bridge. They are a combination of both beam and suspension. Suspension bridges hold the "deck" (where vehicles cross), via the cables, hence the term "suspension"; whereas, a cable stayed has the deck connected via the cables to anchorage points.

The Sydney Harbour Bridge is not the largest bridge in the world. There are many longer bridges. However, it is the largest steel arch bridge in the world, but not the longest. It's arch stands 134 m above the waters of Sydney Harbour.

It depends of what type of bridge you want to make. A big one or a small one. I tell you how to make the small one. The best, I think, you should use triangles for you bridge, no matter the material is wood or metal.

They are supported by pillars are column's.

An example of a beam bridge is Chesapeake Bay bridge-tunnel

Site: http://www.pbs.org/wgbh/buildingbig/bridge/index.html

You can use most diodes for that purpose, and particularly silicon diodes. However, you should not use zener diodes and similar for rectification purposes. Otherwise, you will likely not get the intended result. If the voltage exceeds the avalanche voltage, then the zener diode will no longer rectify, but conduct the other way as well.

-- The center of the west tower, at the Fort Lee end, is located at

40.8528° north latitude

73.9586° west longitude.

-- The center of the east tower, at the Manhattan end, is located at

40.8506° north latitude

73.9468° west longitude.

Items of Work which are below the Bearing viz pile cap, pier, pier cap are consdered as sub structure whereas the items above the Bearing viz girder and deck slab are super structure. Ansered by Rajiv Shah

To spread the force being exerted on them from the weight they hold up over as wide an area as possible to help prevent damage

no Asian wooden kung fu bridges are

Arch bridges are in the shape of an upside down "U" with mainly steel beans, while supension bridges have one or two Major verticle beams with strong wire connecting to the bridge.

A clapper bridge is a type of simple, ancient bridge design that has been used in various parts of the world for thousands of years. While there are some advantages to this type of bridge, there are also several disadvantages to consider, including:

Limited weight capacity: Clapper bridges are typically constructed of stone slabs or logs that are laid across supporting piers or abutments. As a result, they have a relatively low weight capacity and are not suitable for supporting heavy loads, such as modern vehicles or large groups of people.

Vulnerability to flooding: Because clapper bridges are typically built at or near water level, they are vulnerable to damage from flooding and erosion. During times of heavy rain or high water, the bridge may become submerged or washed away entirely.

Difficulty of maintenance: Clapper bridges are often located in remote or hard-to-reach areas, making maintenance and repair work difficult and expensive. Over time, the bridge may become damaged or decayed, requiring extensive restoration work to keep it in good condition.

Safety concerns: Clapper bridges are typically low to the ground and lack railings or other safety features, which can make them dangerous to cross, especially in wet or slippery conditions.

Overall, while clapper bridges are a fascinating historical artifact and can be aesthetically pleasing, they are not always the most practical or safe solution for modern transportation needs.

aeronausiphobia

by two bridge and two lane underground bridge

Monitor-Merrimac Memorial Bridge-Tunnel was created in 1992.

Auburn Tunnel was created in 1821.

Architects are "What"

Engineers are "Why"

and the Trades are "How"

cAN BE Risikesh Laxman Joola .

It is well said that all the great people in the world there is awoman's hand behind. Hence, when Mr. Chips got married with theyoung and beautiful Katherine Bridges, after her marriage with Mr.Chips, she exercised great influence upon Mr. Chips

Gotthard Rail Tunnel was created in 1881.