answersLogoWhite

0

Chevy Aveo

The Chevrolet Aveo is a subcompact car manufactured by General Motors in two generations from 2002 to the present. The first-generation Aveo was available as a three-door hatchback, a four-door sedan and a five-door hatchback.

712 Questions

Where is the hydraulic clutch reservoir located on 2011 Chevy aveo?

The hydraulic clutch reservoir on a 2011 Chevy Aveo is typically located near the back of the engine bay, on the driver’s side. It is mounted on the firewall, often near the brake fluid reservoir. The reservoir is usually a small, translucent plastic container with a cap labeled for clutch fluid.

How do you replace a head gasket in a 2005 Chevy aveo?

To replace the head gasket in a 2005 Chevy Aveo, first, disconnect the battery and remove the intake manifold, exhaust manifold, and any associated components to access the cylinder head. Carefully unbolt the cylinder head, making sure to follow the proper sequence to avoid warping. Clean the surfaces of the engine block and cylinder head, then position the new gasket and reassemble everything in reverse order, ensuring all bolts are torque to the manufacturer's specifications. Finally, refill the coolant and oil, reconnect the battery, and start the engine to check for leaks and proper operation.

Where is the fuel filter located on a 2010 Chevy aveo?

On a 2010 Chevy Aveo, the fuel filter is located underneath the vehicle, along the fuel line. Specifically, it can typically be found near the fuel tank, often mounted on the chassis or close to the fuel pump. Accessing it may require lifting the car for safety. Always consult the owner's manual for precise location and replacement instructions.

How do you change heater blower motor 1999 Chevy astro van?

To change the heater blower motor in a 1999 Chevy Astro van, first disconnect the negative battery cable. Remove the passenger side kick panel and locate the blower motor, which is typically situated under the dashboard. Disconnect the electrical connector and remove the screws securing the blower motor. Replace it with the new motor, reattach the screws and connector, and reassemble the kick panel before reconnecting the battery.

Where is 2004 Chevrolet aveo purge valve?

The purge valve on a 2004 Chevrolet Aveo is typically located on or near the engine's intake manifold. It's part of the evaporative emissions control system and is connected to the fuel tank vent line and the intake manifold. To access it, you may need to remove some engine cover components, depending on the specific engine configuration. Always consult a repair manual for detailed instructions and diagrams specific to your vehicle.

Where are timing marks for 1.6 liter Chevy aveo?

The timing marks for a 1.6-liter Chevy Aveo are typically located on the crankshaft pulley and the timing cover. You'll find a notch or mark on the crankshaft pulley that aligns with a corresponding mark on the timing cover to indicate the correct timing position. Additionally, the camshaft may have its own marks that should align with the engine block or cover when the engine is at top dead center (TDC). Always refer to the specific service manual for precise locations and alignment procedures.

How do you replace Chevy aveo wheel stud?

To replace a Chevy Aveo wheel stud, first, safely raise the vehicle and remove the wheel. Next, use a hammer to drive out the damaged stud from the hub. Insert the new wheel stud from the back of the hub, and then use a spacer or the wheel to pull it through by tightening the lug nut. Finally, reassemble everything, ensuring the lug nut is torqued to the manufacturer’s specifications.

What is the firing order for a 2009 Chevy Aveo?

The firing order for a 2009 Chevy Aveo with a 1.6L engine is 1-3-4-2. This means that the spark plugs fire in the sequence of cylinder 1, followed by cylinder 3, then cylinder 4, and finally cylinder 2. This order is essential for the proper operation of the engine and its performance.

How to change radiator hose for Chevy aveo?

To change the radiator hose on a Chevy Aveo, start by ensuring the engine is cool and then disconnect the negative battery cable. Use pliers to loosen the hose clamps at both ends of the old hose, then carefully slide the hose off. Install the new hose by sliding it onto the fittings, securing it with the clamps, and finally, reconnect the battery cable. Make sure to check for leaks by running the engine and monitoring the new hose.

How do you replace 2009 Chevy aveo throttle position sensor?

To replace the throttle position sensor (TPS) on a 2009 Chevy Aveo, first disconnect the negative battery cable to ensure safety. Locate the TPS on the throttle body, remove the electrical connector, and unscrew the sensor from its mounting. Install the new TPS by securing it in place, reattaching the electrical connector, and finally reconnecting the battery cable. Be sure to check for any error codes and perform a throttle relearn procedure if necessary.

Is Chevy Aveo worth buying?

No!!!!! Many problems with the timing belt possibly costing thousands.

What is the stock speaker size for a 2004 Chevy aveo?

Front door speakers are 4" - 5"; answers I've been finding vary. Rear speakers are 4"X6", but all after-market speakers seem to require some modding of the mounting area. These answers are for the hatchback, BTW.

How do you pronounce the Cheverolet Aveo?

ah-vay-oh or ah-vee-oh I would have to agree with ah-vay-oh. It always sounds dumb when people pronounce it the other way.

What does it mean whenFlashing hold light in Chevy aveo?

A steady on "Hold light" means you pressed the hold button next to the shift lever, repress to disengage.

A flashing "hold light", usually accompanied by the flashing check engine light means the car is in limp mode.

Limp mode stops the transmission from switching to forth gear and engages at 35 mph.

Check the Manifold Absolute Pressure sensor wiring, should have 5volts between the outer two wires with ignition turned on and the middle wire to outside wire voltage should change 1-5volts when you start the vehicle, also check the vacuum line for cracks.

Check the Throttle Position Sensor connector.

If both are good remove the plastic cover from the top of the engine and you will see the Camshaft Position Sensor between the camshafts on a 2005 or earlier Aveo disconnect the plug check the ohm reading between the pins it should be between 460-620 ohms.

If none of the above finds the problem then it probably needs a relearn procedure on the cam position sensor, this can only be done at a dealership.

Disconnectinng the battery for 15 mins usually resets aveo service lights if the problem is still there the flashing hold light will come back on.

Where is the reverse light switch on a 2004 Chevy aveo?

Light comes on automatically when you put transmission in reverse, must be built in safety.

How do you reset the ac compressor for charging Aveo?

If the system is being completely filled, a vacuum will have to be pulled on the system. If the system just needs to be topped off then a vacuum pull is not needed.

Is Chevy Aveo good?

i have a 2005 Chevy Aveo. I've had it since 2007 and it has been a great car and continues to be a great car. I drive a lot and have put over 100,000 miles on it. Just like any car you have to take care of it. Aveos are pretty cheap cars. and mine has been kicking along with no problems so far. she handles good too not a lot of power when the airs on but a lead foot is good for that :) HAPPY owner of my AVEO

How many miles to the gallon does the Chevy Aveo get?

The 2007 Chevy Aveo automatic models have 26 city and 34 hwy MPG.

The 5 speed manual transmissions have 27 city and 37 MPG.

The fuel tank holds 11 gallons.

How do you reset the check engine light on a Chevy Aveo?

There are many reasons for that check engine light. You could go to dealership. Or you could simply disconnect battery and reconnect after 3 minutes.