What causes a strong smell of gas inside your 1991 z28?
I would think that you have a rusted fuel line that is leaking. It is very common in older (10 +)vehicles. You should find the source of the leak and replace the fuel lines. Get a knowledgeable mechanics advice.
fuel filter
.........................................
I have a Camry (yes i know its completely diiferent), and my car is doing the same thing pretty much, gas mileage isn't so good if you have to sit at red lights with your car revving lol. Anyway you might want to look into the egr valve, does the car start right up? If not do you give it a few seconds and try again then it does? (i found hitting, lightly, the egr valve stopped it from sticking and it would restart.
How do you get engine codes for service engine light on on a 97 camaro Z28?
You must have the computer scanned for codes. No other way on a GM after 1996
Rick
I'm a retired ASE Master/L-1 Technician. I still keep current with the latest automotive technology. Visit my blog for cool articles and TSB's: http://free-auto-repair-advice.blogspot.com
Clean the base metal use a high temperature flux using a torch capable of getting the base metal almost cherry red and if you braze the joint properly your tensile strength should exceed 87,000
The selective traction control didn't appear until the 1998 model year but traction control started to be installed in 1995.
How do you take decals off a car?
I use a hair dryer to loosen glue and the clean with thinners
Use cigarette lighter fluid to clean off the old glue it works and it will not take off your paint.
WD40 works wonders too.
Where is the fuel filter located on a 2002 Chevrolet Camaro Z28?
Look under the vehicle along the fram - follow the fuel line from the tank Look under the vehicle along the frame - follow the fuel line from the tank
How do you remove sticky tac from carpet?
Place a paper towel over the sticky tac and then lay a warm iron over the paper towel. Keep moving the paper towel to clean areas as they heat up and transfer onto the towel. This works great for candle wax on carpet too.
Why is a stolen car impounded after being found?
Answer
Stolen cars are impounded for a few reasons. One would be that the Police might want to check it for finger prints. Another reason that the car would be impounded is if it was stolen, and the police think it was stolen too easily, they might want to check for Insurance Fraud and last but not least, they might impound a car while trying to find the owner.
What is the value of a 1969 Camaro?
It really depends on the condition on the camaro, a '69 can range anywhere from $25,000-$70,000; sometimes even less if it's a project car.
How much does a 95 Camaro z28 have?
if your talking about horsepower and torque this is what it has
HP - *275@5200 (automatic or manual)
Torque - 325@2400 (automatic or manual)
*California Dual-Cat cars (automatic only) made 285 hp
Does a 1997 30th anniversary camaro have timing?
Well i will try to answer this question for you. I am assuming that you are asking if you can adjust the distrubitor. I belive not to the best of my memory when i replaced mine. So to answer our question, no. I do belive that you can adjust the timing with a computer programer. You can check those out at SLP performance.com And finally if you are asking if there is a timing chain, yes there is.
How do you remove mascara from carpet?
Eyeshadow, mascara, blusher - washing with your usual laundry product may remove these stains. Pretreat the dry fabric stain with a laundry pre-soak (spot stain remover). On an unwashable fabric, first try dry cleaning fluid. If stains are stubborn, sponge with equal quantities of methylated spirits (wood alcohol) and household ammonia. (Test on coloured fabrics first). If colour fades, reduce ammonia by half and test again. Rinse in warm water, or wash if possible. Haha.. this happened to the carpet in my room. Take Clorox Carpet Cleaner or whatever you use and spray it over the mascara stain. Then, using an old toothbrush, scrub it well. Then put a paper towel over it for a few hours and it should come out.
Where is the starter located on a 97 v6 camaro?
Try rear of engine either driver's or passenger side bottom--follow + battery cable
Your trunk wont close all the way on a 91 camaro z28 is it some kind of electrical problem?
There could be an electrical problem stopping the trunk from shutting all the way. The solenoid that closes the trunk could be weak or out of adjustment.
Where is fuel pump relay on a 1994 Camaro z28?
It would either be under the hood in a fuse/relay box or on the driver's side of the dash board (open the door and it will be on the side of the dash) where the fuse panel is. It will tell you what fuse goes to what.....a/c, heater, radio, etc. Hope this helps.
the fuel pump relay is under the hood of the car in the relay boxes it will say fuel pump on it
If you have no cover for your fuses how do you tell which fuse is the right one for the fuel pump in the 1994 Chevy camaro z28 ?
How do you replace a heater core on 2002 camaro z28?
Remove the water from your 2002 Chevrolet Camaro cooling system. Remove the water supply hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
2 4 is twenty four whats 2 4 ok its not that hard when u look at it carefully
How do you fix dado panelling allowing for movement?
I do my owm d.i.y at home, and have put up dado in the following way. Once you've found your height level using your spirit level to draw a line from left to right etc ect on the wall, get an accurate straight line and have cut your dado to size. then i have usually applied a clear silicon with silicon gun, which can stretch with movement and most d.i.y stores do silicon that can now be painted over as well. Apply the silicon to the back of the dado using a zig-zag motion all along the back of the dado, then place onto wall ensuring you keep to your line you have drawn on the wall. Have a hammer and a couple of tack nails which are as thin and as long as a normal picture nails, and tack lighty one nail in the middle of the dado at the top and also one on the left and one of the right of the dado also at the top this is just to keep the dado in place whilst the silicon is drying, so ensure you only slighty bang in these small nails no more than 2mm into the wall so you can easily get them out. Repeat the process around your room, remove any excess silicon by rubbing a wet finger along the dado picking up all the excess. Give the silicon time to dry as it says on the bottle, or as i usually do wait 24 hours to be safe. Once dry i usually fill in any gaps that are showing with the silicon and then run a wet finger along the edge to rid any excess.When you remove the nails, fill in holes with polly filla and sand or decorators cork which can also be painted over. Hope that helps. Have fun
An AC accumulators job is to remove moisture from the AC system it performs this function with a package of dessicant inside it. Dessicant is a compound that absorbs the moisture around it. An accumulators job is also store excess refrigerant not being utilized by the evaporator.