answersLogoWhite

0

Chevy Camaro

This category covers general questions about the Chevrolet Camaro, a pony car manufactured by General Motors and sold through its Chevrolet division. The Camaro was designed to compete with the Ford Mustang. Production of the model began in 1966.

4,208 Questions

How do you bypass the ignition switch on a 1987 Camaro to start the car?

Hi Ed, The normal way to hot wire an auto ignition, has always been to clip a wire to the positive-post on the battery and then run the lead to the positive-post on the ignition-coil. Then, if you have a remote starter switch, simply crank the engine and it will start. If you do not have a remote starter switch, take a short screw-driver, (or something metal), and cross the two posts on the starter solenoid and crank the engine to start. To shut the ignition hotwire off, simply disconnect at the battery. Thats the simple and easy way. Of course, if you're gonna really fix the thing, you'll need to get into the main ignition switch, etc, etc,...understand? Hot-wireing is just a short term thing! Also, make sure you have the proper AUTHORITY to do all of this!

Can you put a new ignition to replace one that has a chipped key on 1994 caprice classic?

You can bypass chip to set it always on and replace ignition w/o chip. This will save you a lot of headaches.

How do you know if your head gasket is bad?

A visual check of the oil can tell sometimes. Oil should not look brown, milky or have bubbles in it. Sometimes excessive smoke from the exhaust can be a sign. Excessive coolant consumption and a lack in power might be another sign. Another more involved way is a compression check on all the cylinders. That will tell you if there is a leak from the combustion chamber and which cylinder/cylinders.

Is the 1981 Chevy Camaro coupe a four seater?

Yes, but the people in the back shouldn't be large people.

Can you change the drum brakes on a 1996 Camaro rearend and put 2001 Camaro disk brakes on it?

A 1996 camaro has the same DISK brakes as a 2001. It does not have drum brakes.

How do you change ignition switch on 2001 camaro?

The actual switch is located on the top side of the steering column above the brake pedal. it is an electrical & mechanical switch unit changing mechanical action to electrical signal. it mounts to the column with a couple screws or nuts and usually needs to be adjusted via elongated mount holes to a proper fit. this can be achieved by turning the key tumbler assembly to the start position and sliding the switch closer to the steering wheel until the starter engages.

Why is your 96 Chevy Camaro brake pedal hard?

Most likely the vacuum has been disconnected from the power booster. ie. a line is off (engine should run rough) or the plastic check valve is defective. You should hear a sucking sound from the hose connecting manifold vacuum to the brake booster. repair the leak and you should be OK. Its always possible the booster has failed. that is uncommon but expensive. Good luck

How do you bypass the electronic chip in your key for a 99 Ford Ranger?

The easiest way to get around the Transponder Chip in your 99 Ford Ranger is to have a chip programmed and mount it under the steering column cowling close to the inductor coil on the ignition lock. That way you can use non Transponder keys to start the vehicle.

Where is the o2 sensor located on a 98 camaro?

on the v6 there are 4. bank one and bank two are the o2 sensors on your exhaust manifolds with bank one being the driver side. there is also one before and one after the catalytic converter

How much hp does a 1988 Camaro 2.8L engine have?

Less than most 4 cylinder cars today.
In actuality, the 2.8L v6 has more the same or more power than the larger 305 v8. The 1988 camaro with a 2.8L v6 has between 190 and 230 hp compared to the 305's 190 horsepower.


idk how that would be you have to have like a 24 valve engine with a dual cam and nice exhaust manifold to do that much hp in those old car i would say the 2.8L about 120 and most V6s now days are like 140-160 NON-TURBOED that is

Why would your 1995 Chevy Camaro white smoke coming out of exhaust?

its coolant could be a head gasket or the coolant can actually rust trew the block or the head check the dip stick if its a creamy and it smells nasty or check you colant if it smell like cofe then you know coolant is getting in were its not supose to. white is coolant blue is oil and black is fuel hop that can help you

Why did Chevy stop making the camaro?

because it's heavy, guzzles fuel, doesn't really go fast, doesn't stop too well, and doesn't like corners much either. Build quality was awful, dealership support was intermittent at best, insurance premiums were high, safety features were minimal, and it had a bad habit of turning into a fireball when lightly rammed from behind. All round, it was a bit of a design failure.