answersLogoWhite

0

Chrysler Pacifica

Includes information and repair questions about Chrysler Pacifica model cars

645 Questions

Location of rear abs speed sensor on 2005 Chrysler pacifica?

There are 2 sensors in the rear (and 2 in the front). The rear sensors are located on the bottom of the hub and bearing assembly. You will have to take off: The wheel, the brake caliper (with pads), and the brake rotor. After that there are 4 star head bolts (need a socket for them) to remove. Unclip the wire for the sensor as it leads from the hub to the body. Hopefully your hub is not rusted and will come out with a little tug. Otherwise get some penetrating oil and a slide hammer. Once the hub is out a small hex head will take out the bolt that holds the sensor in the hub. Clean everything before reassembly. Small amount of grease (should come with the sensor) on the sensor o-ring before installing it.

Good luck!

Where are fuses for hatch Chrysler pacifica?

The fuse box is under the hood, and the hatch is #11 - 40amp.

Is there a Cabin Filter on a 2005 Chrysler Pacifica?

Usually on anything higher than the 'base' model. Under the dash on the passenger side. Remove skinny clip on panel and pull filter directly out the bottom.

How do you aim the headlights on a 2005 Chrysler pacifica?

There is an adjusting screw on the top of the headlight housing. Turn it left or right to adjust up or down. There is no side to side adjustment.

Where do you tap into the wiring for trailer wiring for a 2005 Chrysler pacifica?

I had someone install my wiring but it is through the back storage area (where the stoage door is). It goes under that tray and we just tuck it in the stoarge area when we aren't using it.

Was there a recall on Chrysler Pacifica paint?

If you call your local dealer with the VIN number they will check for any open recalls for you.

If you call your local dealer with the VIN number they will check for any open recalls for you.

How much it cost to replace an alternator for a chrysler pacifica?

the alternator + replacing fees lies between $350-$400 if the alternator is remanufactured (not brand new). The cost may reach $600 if it is brand new

Why do the dash lights on your 2005 Chrysler pacifica stay on with the key off?

Delay if they do not go off after the delay time look for faults in the BCM

How do you remove the starter on a 2005 Chrysler pacifica?

Remove the front exhaust manifold and remove it from the top.

What is the drive cycle for a Chrysler Pacifica?

I have noticed with these vehicles it is very difficult to get the monitor for the catalyst and the oxygen sensor to complete itself. I work in a auto repair facility and found the best way to get them to set is to get the catalyst hot so take it up some hills and dont be afraid to use the gas pedal. If you choose to do a long drive to get the monitors to set dont use the cruise control and make sure you accelerate rapidly and keep your foot on the gas pedal no on off with the gas pedal.

What is the process to check the timing belt if it needs replacement on a 2004 Chrysler pacifica?

It is a mileage interval, not an inspection. If you have 100,000 miles then replace it.

It is a mileage interval, not an inspection. If you have 100,000 miles then replace it.

Where is the ac port on Chrysler pacifica?

The air conditioning port can be found on the top and the bottom of the air conditioning compressor. There are two air conditioning ports.

Where is the antennae on a 2004 Chrysler Pacifica?

The radio antenna is part of the rear defroster in the rear window.

I believe the radio antenna is in the slanted far-rear window on the passenger-side.

How do you tune up a Chrysler pacifica?

The spark plugs are 100,000 mile plugs.

You need o replace them with platinum plugs, then remove the throttle body and idle speed motor then clean them and reassemble it. There are no spark plug wires on the 3.5L engine.

Where is block heater plug on a 2007 Chrysler Pacifica?

The pig tail to plug into is located on the driver's side near the battery.Find that and follow the cord down to the block.

How do you change brake lights on a 2004 Chrysler Pacifica?

For the lower ones open the hatch and near the light bezels are two 10mm head bolts. Unscrew them, then gently pull the tailight bezel rearward as it fits in a plastic pushin holder. The bezel will slide out of this holder then you can replace the appropriate light by just twisting a 1/4 turn the bulb holder in the back of the bezel. When reinstalling the bezel put a little lube on the pushin pin and the bolts. This will make it easier next time. I am not sure on the center one, I haven't replaced it yet. MGL

How do you change the rear wiper blade on a 2004 Chrysler Pacifica?

The rear blade is a fairly easy installation. Take a close look at the mount which should be a hook-end wiper arm. See sources and related links below for info on the wiper blade and installation videos. Its literally a snap once you have the right part and you see it done once.