Chrysler Pacifica

You open the rear hatch, and remove the two plastic hole covers from the top center trim piece. They allow you to access two phillips screws that go straight up. Once both screws are out, that center trim piece snaps down (it is held by three plastic snap clips). With that piece out of the way, you can reach up above the headliner and get to a 10mm bolt that secures the antenna base. Two wires attach to the antenna, and the connectors are easy to disconnect once you find the tab to release them.

Red, five year, hoat type.

There is a button on the dashboard,, just right of the instrument panel, it says us/met.

Depress that button and everything turns to opposite of what it was.

It doesn't have a mass air flow sensor.

It is a non serviceable trans and cannnot be checked at home. It must be taken to a dealerahip.. UGH

True, the dipstick is a dealer only special tool.

A diagram outlining how to replace a blower motor in a Chrysler Pacifica can be obtained from most auto-parts stores. Many Chrysler dealerships will also make the diagram available.

110 ft lbs

I don't have a 100% exact answer, but here is what I have: 2007 Chrysler Pacifica FWD Change from OEM (17 inch) to: rims: Ace Executive 22 x 9.0 offset +35mm tires: Yokohama Parada Spec-X, 265/35x22 No clearance issue. Even at 35% (vs. the 65% on the 17 inch), this combination is not riding harsh at all. I will install lowering springs (-40mm) next (unfortunately, custom springs needed).

3.8L has a chain.

3.5 or 4.0L has a belt.

Red, 5 year, HOAT type.

No, it does not.

1/2 socket and wrench and rubber mallet

The Chrysler Pacifica has U-Hook wiper blade arm attachments. See video below for Hook-End arms. Essentially there's a tab or button where the wiper blade is inserted into the hook. Press the tab/button and pull wiper out of hook. Sometimes you may have to rotate and flex the blade to make enough clearance. Lastly, your new replacements should have these same instructions on the packaging.

No

No

36 psi

Automatic transaxle

Automatic transaxle

It has a belt. The 2004 model was only offered with the 3.5L engine. Chrysler recommends 1st inspection at 70,000mi. Then every 15,000mi after unless you change it, then mileage starts over. MGL

Just call your local autoparts store, such as Autozone, and give them the details of your vehicle, and they can look it up on their computers and give the size of wiper blade you will need.

You have to remove the pan to drain the transmission.

You have to remove the pan to drain the transmission.

Sure you can use snow tires, Im not really sure why you would want to unless yours is front wheel drive. The only side effect that I can think of besides the added cost is that your ride quality may be a little less smooth than with the all season tires.

You squeeze the clamp with a pliers.

The 2006 Chrysler Pacifica has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.

In the little storage area in back...lift up the molded carpet panel. The jack is on the left going toward the bumper.

3.8L has two.

3.5L and 4.0L have four.