Chrysler

This will depend on the vehicle that you are looking at. Chrysler makes a lot of different vehicles and they all have abbreviations.

Usually a malfunction switch. The switch works on resistance that is read by the BCM then it turns on the wipers and selects the speed.

There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.

The reason it blinks is it is warning that the catalytic converter is on the verge of overheating because of misfires in the ignition system.

Which engine? The 2.7 V-6 has three bolts. Look at a replacement starter for your vehicle and you can see the bolt pattern. Any online parts house has pics of the replacement and you can see the bolt configuration. Bet you will see one on Ebay.

Sometimes they will just stick. Try hitting it on the rear with a rubbber or plastic hammer, and see if it will come loose.

Inline, 1-5-3-6-2-4

V6,1, 2,3,4,5,6 or 1,6,5,4,3,2 it depends on the engine.

1-5-3-6-2-4

What do you mean by interference?

Is it that it will not destroy itself when the timing belt brakes at 3000RPM's?

It is a free wheeling engine and will not destroy itself.The 2.7 V6 and 2.4 4cyl on the other hand will self destruct are dual cam and four valves per cylinder.

"Chrysler's primary goal is to achieve consumer satisfaction. We do it through engineering excellence, innovative products, high quality and superior service. And we do it as a team." (1988)

Cars, Customers, and Returning to Profitability

Unless you have a good memory there are a lot of screws bolts,plastic pieces to destroy and it is very doubt full it will be put together without everlasting and annoying squeaks and rattles. Better take it and have it fixed, it is better to complain to someone that screw it up than kicking yourself.

Well the sensor itself dose not leak there is a thin round gasket that is made into the sensor it keeps the seal between sensor and camshaft they are a common place for oil leaks. I just replaced the one on my 97 neon they are they are thin and black it was hard to see but it on there I used a knife to get the old one out. Cheap part and easy to fix 5-10$ at a dealership.

188hp

Raise and block car remove fill tube and lines from fuel pump and emission lines,

place a jack or support under the tank and remove straps.

CAUTION FUEL EXPLODES WITH SPARKS

Walter P. Chrysler

Not any more.The president decided to give to Fiat which has still to produce a car that lasted.

The higher the better as long as it fits

In my 2006 the rear window washer fluid shares the same tank as the front window washer. The operators manual also makes this statement. 1995 and before you fill the rear by opening the liftgate and adding fluid to the reservoir just above the left taillight. 1996 and later the front reservoir is for both.

Google it and at least one will come up but you could have a manual and just not know it that's what happened to me. It was hidden in a small shelf inside my glove box.

Actually, you can go to Jeep.com..they have online manuals there

This car has two. The first one is on the driver side of the engine compartment by the battery. This holds the relays and j fuses for the major functions of the car. The second one is inside the glove box. open the box and look to the left it is right there. This one holds all your internal fuses, like radio, dome light, etc.

Hydraulic fluid?? Are you referring to Brake fluid? Dot 3.

Do you know how many years that Chrysler has been building the Town & Country? Ever since the 50s with many different engines. Drain the oil and change the filter. Add 4.5 quarts and start the engine. Run for 45 seconds and shut down. Wait 45 minutes and check the level and add as necessary. You now know the capacity.

34,000 BTU's

If the torque converter is empty it takes 5, if you dont know put a couple quarts in start your vehicle and while its running check it. Hope this helps.

Its probably a low tire indicator. Meaning one or more of your tires needs some air. To be sure I would check the manual.

The 2001 Chrysler 2.4L 4-Cyl. (DOHC) has a timing belt and it must be replaced at 120,000 miles. This is an interference engine and if the belt breaks serious engine damage will occur. BTW, the water pump is driven by the cam belt. Replace the pump at the same time you replace the belt. They have approximately the same life expectancy and this will save you labor cost later when the pump fails, which it will.

196.8 inches