What are the two major types of glaciers and where do they form?
What part of glacier moves fastest when the glacier moves by internal plastic flow?
The central part of the glacier moves fastest than its edges as it is thickest from the center.
The rock is called a glacial erratic when it is left behind by a glacier, and is of a completely different material composition than the rocks on which it was deposited.
Can melting glaciers increase ocean acidity?
No. Melting glaciers add clean fresh water to the oceans, so their melting decreases ocean acidity.
When a glacier stands still the ice within it is?
still flows and carries debris to the end of the glacier
What latitutes are most likely to see glaciers?
Latitudes that are most likely to see glaciers are maritime areas north of 35˚N and south of 35˚S
Wish
What material will provide the best insulation?
Can Called GOOD STUFF for small cracks and around electrical outlets,pipes,cables,conduit and dryer vents. the stuff cuts easily after drying for a night with a bread knife,then can be covered, if needed :with some painters or sylicon caulk then some paint for a smooth finish. home depot and lowes have it.
Your ZX2 runs very rough at idle then smooths out when accelerating?
== == == == We had this problem with our 2001 escort and we were told that we had a lot of carbon build up. We had a tune up and a carbon flush and it did way better. I had this problem, I thought it was electrical since it mainly happened when I turned on the lights or heater. I changed out the fuel filter and the problem was fixed. I also have a small vacuum leak in a hose off the valve cover that adds a little to the vibration. Answer My 98 zx2 has the same problem. I took it in and my mechanic told me that there had been a maintenence recall on the transmission mounts. they said the transmission mounts on zx2s tend to wear out over time and that causes the vibration. they also said you'll know that's the problem if it smooths out in neutral. Tune up will probably help. Kind of sounds like your fule filter may be cloged. if the cam belt has been changed recently the cam positioning sensor could be bad so if you know someone with a programmer talk to them to be sure This could be due to damage/deterioration of the motor mounts. The next time you take your ZX2 in to be serviced ask the technician to check the motor mounts for excessive wear. I was experiencing this very issue on my 2000 ZX2 and it turned out to be a leak in the hose that connects to the PCV Valve. Replaced the hose and the engine smoothed out. ANSWER This is due to a design issue with the engine. There is a Technical Service Bulletin from Ford TSB 031515 that involves reconfiguring the motor mounts. I've chosen to just live with it.
Answer: Cirques