HDTV

The Soyo Group, in Korea

You have to open the back of the tv(remember safety),look for three knobs,a red,a blue,and a green knob.You will have to tune each knob seperately,tune down the red and adjust the other two until your image is repaired.This could be caused by exposing your tv to a magnet.Remember that this is dangerous and you can shock.(",)

I would highly advise against tuning anything on a TV which has changed display on its own. I use to repair electronics for living and a symptom like that indicates a circuit failure in the TV. Any 'knobs' better known as variable resistors are pre-set at the factory and usually painted on one side to indicate and keep the factory setting. The only time you should mess around with those is if you do a CRT (aka tube) replacement to recalibrate the electronics for the new tube display.

To fix the described condition you will have to troubleshoot and replace the failed component (usually a transistor or an IC [integrated circuit]). You can try doing this on your own but a repair shop is usually the better choice since they have access to schematics, troubleshooting equipment and replacement parts. Good luck!

Your TV is unlikely to have a S-Video output to go to the projector. What most TV's had was a S-Video input, to come from a Super VHS VCR or older generation gaming console.

If indeed the TV has a S-Video OUTPUT, and the projector is set to the correct input (usually this has to be changed in the input menu) and you are still not getting any picture, I would check the S-Video cable for bent pins. The cable's pins are very thin and can easily be bent or broken off with rough handling.

This model has an HDMI input. If you can't see a picture when you connect your playback device to the TV with an HDMI cable, you might be on the wrong input on the TV (press the TV/Video button or Source button) or you may have a HDCP issue with the playback device. If you are using a surround receiver or switch for the HDMI inputs, try going directly to the TV. Some receivers can block or corrupt the High Definition Content Protection signal, causing no picture to be output.

No, most projectors do not have TV tuners. You will need to connect the antenna to a digital TV tuner, and then connect the tuner to the TV.

Call Verizion

,

you will

have pay more money to receive the HD program's.

HDMI is better because it can send digital audio on the same cable, is a smaller connector (more portable) and can support 3D. DVI is better because it has a locking connector, can support both analog and digital video and does not need to support digital rights management, so can be easily split, copied and amplified.

You might find this switch in the audio menu on the set or look for the letters CC or SAP on the remote.

Very few manufacturers sell direct to the public or end users. Most rely on networks of distributors and dealers to generate high levels of business. If a manufacturer also sold to the end users, dealers would be less supportive of that manufacturer.

Also, manufacturers are generally not set up to provide the level of customer support that a good dealer can and does offer.

Of course, there are exceptions. In the main, manufacturers of high end equipment may sell to private buyers directly but expect to be spending large amounts of money on a projector or large screen display before you come across this small group of manufacturers.

S-video is an interface standard for video signals only. It used two cables, one for a black and white image and the other for the color information. Audio needs to be routed on separate cables.

Yes. But you will lose signal quality (decreased brightness and increased interference) without an amplifier.

ALL BIG SCREENS HAVE A PLASTIC COVER...SO I IMAGINE THE COVER IS SCRATCHED! REPACE COVER? CALL A TV REPAIR FOR QUOTE

The optical cable would be the best choice.

Broadcasts intended for an audience in Japan are not available in Europe. If they are terrestrial broadcasts, the transmission power and earth's curvature will prevent the signal reaching Europe. Satellite transmissions are focussed on a certain area, known as the signal footprint. Once again, those signals will not be available in Europe.

Choose Setup and Restore Factory. This will reset the password on the lock screen to 0000.

no keep it upright it will mess it up if u dont.

By RGB, we can assume that this is a VGA port that carries RGB analog signals.

HDMI is a fully digital interface so to use this input, a VGA to HDMI converter is required. They are available on line and at some computer and electronics stores and should cost in the region of $30 - $50.

Bluray handles all HD formats. As 720p is one of the HD formats, it will play it without a problem. Bluray will also handle 1080i and 1080p formats as well as standard definition.

Depending on the set up of the player, the output will be in the format recorded on the disc or it may convert all formats to a single format such as 1080p. As an HD television will also handle any of the formats, it is worth experimenting with the set up to see if 720p discs are displayed better when the player outputs the native format or in a converted format.

Can it accept a sound module, that is, can it be connected to a device that contains other sounds (or presets)? Is it MIDI compatible? Does it have weighted keys? Are the keys velocity sensitive.

A good idea these days is to buy a controller. This is just a full size, weighted keys, keyboard. It has no sounds built in. You would connect this to a sound module, or your computer with compatible software. This way, it will never be 'outdated'. Whatever new program or sound that comes along, you can INTERFACE with it directly.

yes isn't it obvious

You cant

Depends which brand and screen size you plan on buying. Prices are generally in line with the latest HDTV offerings, so anywhere between £500 and £3000 for general consumer level 3D TVs. Obviously there will the the usually mega 80 inch 3D TVs from Samsung that will set you back 10 times as much.

SMS bal to 54325 from the Registerered Mobile Number that you gave during installation.

Most CRT-style projection TV's have an alignment / focus procedure accessed by the remote control or through buttons on the set itself.