Mazda 3

at hi rev the piston reciprocates at high speed from tdc(top dead centre) to bdc(bottom dead centre),and there's a cycle in which combustion of charges(fuel and air mixture) takes place,and rate of combustion of fuel can't be increased considerably while high speed functioning,so a little charge is left,which is not fully burnt,it may have un burnt hydrocarbons which looks black,and it is exhausted by the engine,so that's the smoke from your car. and there are other reasons to..like engine's valve mechanism is faulty or problem with the spark plug

4.5 qt w/filter change, 4.1 qt w/o

$45.00 at auto zone for rear and 60.00 for front.

This is an easy task. You need 3 things: a roll of dark masking tape, blue works really well, a medium to large flat screwdriver a #2 works well, and a wall with a level flat driveway, your garage door may work if you have a level flat driveway.

Best to do this when its dark or getting dark, NOT in bright sunlight.

SET dashboard headlight adjustment knob (feature on several Mazda) to position "0". All positions but "0" interfere by compensating. Set it to "0".

Drive your car close to the wall, about 1 foot away works well.

Turn your headlights on. You will see across the wall the top of your lights, below bright above much less bright.

NOW, place a strip of dark masking tape on the wall along that edge of light.

That tape is your Mark for adjusting your lights level.

Carefully and safely back the car straight about 10 to 15 feet, if possible.

Notice where your headlight boundary is now relative to the masking tape.

If it is right along the tape your adjustment is normal, and OK.

If it is much higher that may bother oncoming drivers and should be lowered.

If much below the masking tape its too low, unsafe, you may not see hazards and should be adjusted to raise it.

Be sure engine is turned OFF and headlights are on, be SAFE!

To adjust, Open hood, look for white adjustment toothy wheel with six sided adjustment Slot, located right behind the headlight electrical connector.

NOTE: in some models you may have a plastic snap-on cover above it, unsnap to access the Adjustment with your screwdriver. Use a flashlight to see it.

Insert screwdriver blade carefully into the slot. If you have a proper size screwdriver it should fit in easily and snug, do NOT force it, if loose or tight get another different screwdriver that will fit properly. Do NOT damage the slot, its plastic!

While watching the light on the wall relative to masking tape turn the screwdriver, counterclockwise to RAISE, clockwise to LOWER. Be careful and know it may take from 2 to 5 screwdriver turns to notice movement of the light.

When the light boundary is right at the masking tape you lights are Level.

When necessary do this for each headlight. Same procedure.

Good job, close your hood and drive the car and notice the difference.

If you have dashboard headlight level adjust feature try it, moving from "0" to "1", "2" etc should LOWER the headlight level. This allows you to lower your headlights for city driving and set it to "0" for open road driving where you need more light coverage ahead to see road hazards.

Jay, 2007 Mazda 3

Press and hold the power button and media button simultaneously for 10sec, then release the media button.

A car with a manual or stick shift transmission.

Standard features include many kinds of air bags, dynamic stability control, a blind spot monitoring system, key less entry and start, Tom Tom integrated GPS system and 256 watt Bose audio system.

It's all in the owner's manual - with pictures and procedure. Actually - probably about 90% of the answers to questions asked here are also addressed in the owners manual - that's why it was written and why one is included with every car purchased.

Three and out is a football term. In American football you 4 "downs/attmepts" to get 10 yards. If you get the 10 or more yards than you start over at first down. If you don't get 10 yards after the first 3 downs you can go for it and try to get the remaining yards, punt or you can try for a field goal. A punt is when you kick the ball and the other team receives it and trys to return it into your endzone. The benifit of punting is it pushes the other team back towards the other side of the field and makes it harder for them to score. A field goal is when someone holds the ball and a kicker trys to kick the ball through the goal posts, which is worth 3 points. Anyway, if you go three downs without getting 10 yards and have to punt they call it "Three and out", you've done three plays and now your off the field.

Your emergency brake is to tight on the back brakes, which is not allowing the ABS to work properly. that's why both lights are on. Good Luck

Should be just below the trans fluid level dipstick. There is also a red connector on the hose coming from the air intake tube.

unplug the battery post for a minute and make sure theres no corrosion on the battery, plug it back up, an start your car. if it is some corrosion, pour a little coke on it until if fizz, or put baking soda on it and pour a little water on it (enough to make it fizz up) let it set for a minute and pour clean water on it to rinse it off and wipe clean. once dry put the battery post back and start your car. You just have to reset you radio,clock,etc.

Directly under the intake manifold on the passenger side of the engine. If you have thin arms, it is possible to reach it from above the engine.

Otherwise, if you remove the passenger side tire, you will find it there.

You more or less can't. You will be a stand alone or piggy back ECU and program that instead.

Take off key chain. Use a coin to pop open fob. Button battery inside

You can take it to a Mazda dealer and they can do an update to your car's computer to disable the alarm. I think it's around $50-$75 for them to do that.

To fix the radio display in a 2006 Mazda 3, start by checking the fuse related to the radio in the fuse box, as a blown fuse can cause display issues. If the fuse is fine, try resetting the radio by disconnecting the car battery for a few minutes and then reconnecting it. If the display still does not work, consider checking for loose connections behind the radio or replacing the unit if it's malfunctioning. If you're not comfortable with these steps, consult a professional mechanic for assistance.

The cost of a turbine sensor for a 2004 Mazda 3 typically ranges from $50 to $150, depending on the brand and whether it's an original equipment manufacturer (OEM) or an aftermarket part. Prices can vary based on the retailer and location, so it's advisable to shop around both online and at local auto parts stores for the best deal. Additionally, consider potential shipping costs if ordering online.

In a Mazda 3, the thermostat is typically located in the engine bay, near the engine block. It is usually housed in a thermostat housing that is connected to the upper radiator hose. To access it, you may need to remove some engine covers or components, depending on the specific model year. Always refer to the vehicle's service manual for precise location and replacement instructions.

The serial number, or Vehicle Identification Number (VIN), for a Mazda B3000 is typically located on the driver's side dashboard, visible through the windshield. It can also be found on the driver's side door frame or inside the engine compartment. The VIN is a 17-character code that provides important information about the vehicle's specifications and history. Always refer to the owner's manual or contact a Mazda dealer for specific guidance on locating it.

In a Mazda 3, the fan fuse is typically located in the fuse box under the dashboard on the driver's side or in the engine compartment fuse box. To find it, consult the owner's manual for the specific fuse diagram, which will indicate the exact location and amperage of the fan fuse. Always ensure the vehicle is turned off and the keys are removed before checking or replacing any fuses.

Yes, you can tow a Mazda 3 with a motor home, but it depends on the specific model and year of the vehicle. Some Mazda 3 models can be flat-towed (towed with all four wheels on the ground) if they meet certain conditions, while others may require a dolly or trailer. Always consult the owner's manual for the Mazda 3 and check local towing regulations to ensure safe and legal towing practices.